Vascular embolization is a minimally invasive treatment used for the management of vascular malformations and tumors. It is carried out under X-ray by navigating a microcatheter into the targeted blood vessel, through which embolic agents are delivered to occlude the vessels. Cyanoacrylate liquid glues have been widely used for vascular embolization owing to their low viscosity, rapid polymeriz...

Zinc alkyl cations supported by N,N-BIAN-type bidentate ligands were found to be highly active in the immortal ROP of ε-caprolactone to yield narrowly disperse and chain length-controlled poly(ε-caprolactone), whether in solution or bulk polymerization conditions.

Particles of linear polyethylene (M(n) = (2-3) x 10(3) g x mol(-)(1); M(w)/M(n) = 2-4) obtained by catalytic emulsion polymerization of ethylene possess a nonspherical, lentil-like shape with an average aspect ratio of ca. 10 and diameters from 30 to >300 nm, as determined by TEM and AFM. The particle structure results from a stacking of the lamellae along the one shorter axis of the lentils (i...

Homopolymers of β-lactams can be grown by surface-initiated polymerization. These surface-linked β-peptides are living polymers with the potential to be utilized as tunable, protease-resistant interfaces in multiphase structural composites where the characteristics of the interface influence bulk properties.

The cellular cytoskeleton is a complex dynamical network that constantly remodels as cells divide and move. This reorganization process occurs not only at the cell membrane, but also in the cell interior (bulk). During locomotion, regulated actin assembly near the plasma membrane produces lamellipodia and filopodia. Therefore, most in vitro experiments explore phenomena taking place in the vici...

Multiphoton microscopy of collagen hydrogels produces second harmonic generation (SHG) and two-photon fluorescence (TPF) images, which can be used to noninvasively study gel microstructure at depth ( approximately 1 mm). The microstructure is also a primary determinate of the mechanical properties of the gel; thus, we hypothesized that bulk optical properties (i.e., SHG and TPF) could be used t...

Combining total energy and structure optimization calculations, we explored new possible crystalline phases of covalently bonded C60 fullerenes and determined their structural, elastic, and electronic properties. Motivated by reported observations that bulk structures of polymerized fullerenes may be stiffer than diamond, we have explored possible ways of fullerene polymerization and have ident...

Poly(D,L-lactide) synthesis using tin(II) 2-ethylhexanoate initiated ring-opening polymerization (ROP) takes over 30 hours in bulk at 120 °C. The use of microwave makes the same bulk polymerization process with the same initiator much faster and energy saving, with a reaction time of about 30 minutes at 100 °C. Here, the poly(lactide) synthesis was done in a microwave reactor, using frequency o...

In this work, we report the synthesis, structural characterization of Group 4 mono and bis-hydroxides their derivatives catalytic properties in Ring Opening Polymerization (ROP) rac-Lactide. The hydroxides, multimetallic assemblies were characterized, using 1H NMR, 2D Elemental Analysis, Single crystal XRD. These complexes used as catalysts for ring opening polymerization All exhibit varied act...

The purpose of this study was to compare the properties of 2 new dual-cure, bulk-fill restorative composite resins to those of a hybrid composite resin material. Depth of cure, fracture toughness, porosity, microleakage, and volumetric shrinkage properties were examined. With the exception of fracture toughness, significant differences were found among materials. Compared to the incrementally p...