Superplastic materials show a very high ductility. This is due to both peculiar process conditions and material intrinsic characteristics. However, a number of superplastic materials are subjected to cavitation during superplastic deformation. Evidently, extensive cavitation imposes significant limitations on their commercial application. The deformation and failure of superplastic sheet metals...

The purpose of this study is to investigate bending moment and the axial load capacity of a pressurized pipe suffering from a through-wall circumferential crack repaired by a composite sleeve. The three-dimensional finite element method (FEM) was adopted to compute the results, and the failure assessment diagram (FAD) was employed to investigate the failure behavior of the repaired pipe. The fi...

BACKGROUND Biaxial (BX) and triaxial (TX) composite laminates with ±45° angled plies have been widely used in wind turbine blades. As the scale of blades increases, BX and TX laminates with shallow-angled plies (i.e. off-axis ply angle <45°) might be utilized for reducing mass and/or improving performance. The compressive properties of shallow-angled BX and TX laminates are critical considering...

An analytical investigation is conducted to predict the post-buckling strength of laminated composite stiffened panels under compressive loads. When a stiffened composite panel buckles, the skin would deform into a sinusoidal mode shape, and hence induces additional moments and forces near the skin-stiffener interface region. These induced loads would cause the existing small edge delamination ...

To develop a simplified and physically sound delamination-failure criterion, this paper reports joint experimental numerical study in which out-of-plane quasi-static indentations with different indentation forces were applied to the centre of fully clamped rectangular carbon fibre-reinforced polymer (CFRP) laminates. The results show that two basic micro-delamination growth modes, are separatel...