Abstract The addition of powders in electrical discharge machining (EDM) reduces the breakdown strength liquid dielectric, thereby enhancing occurrence early spark, and aids machinability. Challenges occur sustainability powder mixed (PMEDM) process terms homogeneity powder-dielectric mixture adverse effects these on impellor pump, maintaining concentration powder–dielectric for a wide range at...

Alignment by an electric field was obtained for a variety of particles dispersed in photopolymerizable fluids. The particle shapes studied were irregular, spherical, rhombohedral, rod-like (fibres), and platelet. The sizes ranged from sub-micrometres to tens of micrometres, and the dielectric constants of the particles varied from less than that of the liquid matrix to very much greater than th...

Interdigital dielectrometry is used for non-destructive evaluation of material properties. Spectroscopic analysis of frequency-dependent dielectric properties increases sensitivity and selectivity of measurement of many physical variables (e.g. moisture, porosity, density, and aging status) that are correlated with changes of dielectric properties. This paper presents a convenient algorithmic m...

An apparatus has been developed for simultaneous measurements of fluid densities and dielectric constants at temperatures from 70 to 320 K and at pressures to 35 MPa. A magnetic suspension technique, based on an application of Archimedes' principle, is employed in the density determination, while a concentric cylinder capacitor is used for obtaining the dielectric constant data. The apparatus c...

Recently, photonic crystals doped with liquid crystal (LC) material havegained much research interest. In this article new ternary one-dimensional photoniccrystal introduced and studied. The liquid crystal layer of 5CB and 5PCH is sandwichedby two dielectric layers. For the first time, we use four structures SiO2/UCF35/CaF2,SiO2/5CB/CaF2, NFK51/UCF35/NPSK53 and NFK51/5CB/NPSK53. The effect ofte...

Although all-dielectric metamaterials offer a low-loss alternative to current metal-based metamaterials to manipulate light at the nanoscale and may have important applications, very few have been reported to date owing to the current nanofabrication technologies. We develop a new "nano-solid-fluid assembly" method using 15-nm TiO2 nanoparticles as building blocks to fabricate the first three-d...

This report describes the development and testing of a Galloping Hydro Electric Energy Device (GHEED) which is intended to utilize a Dielectric Elastomer Generator (DEG). The mechanical side of the GHEED includes a shape morphing element, and has been designed to convert the kinetic energy of low head and/or turbulent flows into repeating, oscillating motion. The intent is to couple this motion...