tellurium nanostructures have been prepared by physical vapor deposition method in a tube furnace. the experiments were carried out under argon gas flow at a pressure of 1 mbar. tellurium powder was evaporated by heating at 350°c and 430°c and was condensed on substrates at 110–250°c, in the downstream of argon gas flow. the products were characterized by field emission scanning electron micros...

The effect of Nickel doped Cobalt ferrite nano particles Ni0.2CoxFe2-x04(x=0.1, 0.2, 0.3, 0.5) Created by sol-gel auto combustion technique using citric acid as fuel. single phase cubic structure form confirm the XRD. crystalline size calculated FWHM (311) plane Scherer’s formula. typicalsize sample varies in order regime. structural and lattice parameter were obtained XRD data. surface morphol...

Polyindole nanowires were synthesized by oxidative polymerization of indole using ammonium persulphate as oxidant. The structure of polyindole nanowires was confirmed by XRD, FTIR spectroscopy. The FT-IR of polyindole nanowires shows a peak at1480 cm which corresponds to the C-N stretching of the polymer. The morphology was studied by FESEM, which shows that the synthesized polymer has wire-lik...

Nanocrystalline SnO2 thin films were successfully prepared using sol-gel dip coating technique. The starting precursor was used as tin chloride dihydrate (SnCl2.2H2O), ethanol and glycerin. As the prepared films were fired at 500 o C. These films were characterized using XRD, FESEM and TEM to known crystal structure, surface morphology and microstructure property. Elemental composition was stud...

In this paper, synthesised nanometre sized hydroxyapatite (nano-HAP) powders composed of spherical 30 ± 5 nm part icles were compacted and sintered at temperatures ranging from 650 to 1250°C to form ceramics of varying porosity and mechanical strength. The size, crystalline structure and morphology of both the synthesised nano-HAP particle powders and the compacted and sintered ceramics were in...

In this data article, vertically grown SnS layers were investigated. The growth processes of vertical SnS layers were discussed in our article [1]. This data article provides the chemical analysis using the XPS measurements for the SnS sample grown on a Si wafer. Deposition time varying SnS morphology changes were observed by FESEM. The cross-sectional images were achieved to monitor the SnS la...

A novel wavelength dispersive soft X-ray emission spectrometer (WD-SXES) has been developed. It covers nominally the X-ray energy range between 50 and 210 eV [1, 2]. One of the characteristic features of the WD-SXES is parallel detection of the signal so that it can be used like a conventional energy dispersive spectrometer. One other feature is a high energy resolution, which is about 0.2 eV. ...

A simple and cost effective hydrothermal method has been done for the synthesis of MoS2 and MoS2/rGO nanocomposites. The prepared MoS2/rGO composite was characterized by XRD, FESEM and TEM which revealed the formation and as well as the morphological scenario of MoS2/rGO nanocomposite. Pure MoS2 and MoS2/rGO nanocomposite show 3D hierarchical flowery architecture where rGO nanosheets were inter...

In this paper, iron oxide magnetic nanoparticles were synthesized by co-precipitation method and were functionalized with aldehyde group. Spherical superparamagnetic nanoparticles with diameter of 100 nm were obtained based on the results of field emission scanning electron microscopy (FESEM) and vibrating sample magnetometer (VSM). These particles were further applied for immobilization of enz...

We report a novel type of WO3 nanostructure, i.e. nanorolls obtained as a self-assembled thin film on a transparent conductive substrate. The mild conditions of preparation, avoiding the use of HCl, result in an eco-friendly hydrothermal method with reduced crystallization time. FESEM and HR-TEM show that WO3 nanocrystals are made of rolled nanoflakes with a telescope-like appearance at their t...