Biomaterials-associated infections are primarily initiated by the adhesion of microorganisms on the biomaterial surfaces and subsequent biofilm formation. Understanding the fundamental microbial adhesion mechanisms and biofilm development is crucial for developing strategies to prevent such infections. Suitable in vitro systems for biofilm cultivation and bacterial adhesion at controllable, con...

In this study, a biodegradable/conducting film based on polylactic acid (PLA) modified with polyaniline, zinc oxide, and copper oxide (PLA/PAn/CuO/ZnO) was prepared. The effect of the electrical, physicochemical, antioxidant, antimicrobial properties films by different techniques such as SEM, FTIR, TGA were investigated. Electricity conductive used for intelligent packaging orange juice. chemic...

in view of the importance environmental pollution caused by plastic food packaging, in recent years there is a considerable interest in edible films and coating based on polysaccharides, proteins, lipids or combination of them. edible coatings also serve as carriers of food additives such as anti-browning and antimicrobials agents, colorants, flavor, nutrients and spices, so act as active packa...

Background: The resistance of the bacteria and fungi to the innumerous antimicrobial agents is a major challenge in the treatment of the infections demands to the necessity for searching and fi nding new sources of substances with antimicrobial properties. The incorporation of the essential oils (EOs) in chitosan fi lm forming solution may enhance antimicrobial properties. Howe...

background: ebt and ebt3 radiochromic films have been used in radiotherapy dosimetry for years. objective: the aim of the current study is to compare ebt and ebt3 radiochromic films in dosimetry of radiotherapy fields for treatment of parotid cancer. methods: calibrations of ebt and ebt3 films were performed with identical setups using a 6 mv photon beam of a siemens primus linac. skin dose was...

The effect of surface bond-order loss on the classical resistivity of metallic polycrystalline thin films is studied. The potential barriers due to grain boundaries considered here contain square-well depressions on both sides taking into account the effect of surface bond-order loss for the grains in a film. Electron scattering by film surfaces is also considered following the lines of Fuchs’ ...

Thin films of LaS were prepared by using spray pyrolysis technique at 270 0 C and thickness were varied by changing the concentration of reactant solution. The films were optically characterized and their variations with film thickness were studies. It was found that thickness can be tuned by varying concentration of reactant solution. The band gap was found to vary between 2.35eV to 2.50eV. Th...

Kodak X-Omat V radiographic film has been tested for its polarization properties when using polarized and non-polarized light sources and detectors. The radiographic film has been shown to produce a relatively small but not negligible (less than 5%) variation in 90 degrees cycles in measured optical density within the visible spectrum when the light source is fully linear polarized and the film...

In this work, nanostructured TiO2 and Cr-doped TiO2 thin films were deposited on glass substrate through sonochemical-chemical vapor deposition (CVD) method. The resulting thin films were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), UV-visible absorption spectroscopy, and photoluminescence spectroscopy techniques. The TiO2 thin film has nanocubic morphology and ...