In this paper, the production of Al2O3-Mo nano-composites via mechanical milling was investigated. Molybdenum and alumina powders with certain ratios were grounded in a planetary ball mill at different times. XRD technique was used to determine the crystallite size of the milled powders. The microstructure of milled powders was studied using optical and electron microscopes. The crystallite siz...

Ultrafine-grained (UFG) Ti for improved mechanical performance as well as its surface modification enhancing biofunctions has attracted much attention in medical industries. Most of the studies on the surface etching of metallic biomaterials have focused on surface topography and wettability but not crystallographic orientation, i.e., texture, which influences the chemical as well as the physic...

In this communication we elucidate a microstructural picture of proton conduction in nano-crystalline yttria-stabilized zirconia at low temperatures (Kim et al. Adv. Mater., 2008, 20, 556). Based on careful analysis of electrical impedance spectra obtained from samples with grain sizes of approximately 13 and approximately 100 nm under both wet and dry atmospheres over a wide range of temperatu...

Superplastic structural ceramics (Y-TZP, A1203, Si3N4, and their composites) that can withstand biaxial stretching to large strains have been developed recently. Microstructural design of these ceramics first requires an ultrafine grain size that is stable against coarsening during sintering and deformation. A low sintering temperature is a necessary, but not a sufficient, condition for achievi...

Abstract Metals with a bimodal grain size distribution have been found to both high strength and good ductility. However, the coordinated deformation mechanisms underneath ultrafine-grains (UFGs) coarse grains (CGs) still remain undiscovered yet. In present work, Cu 80% volume fraction of recrystallized micro-grains was prepared by annealing equal-channel angular pressing (ECAP) processed ultra...

in this study, the effects cold rolling and annealing parameters during thermomechanical processing of the aisi 201ln stainless steel were investigated. the cast samples were homogenized, hot-rolled and solution-annealed to acquire a suitable microstructure for the subsequent thermomechanical treatment. unidirectional and transverse multi-pass cold rolling at 25, 0 and -15 °c was carried out to...

Introduction and Background: Ceramics are inorganic, nonmetallic materials, such as alumina, beryllia, or glassceramic, whose final characteristics are produced by subjection to high temperatures. Nanomaterials is a rapidly growing area of ceramics [1-3] and can be classified into the following categories: Nano-particles submicron or ultra micron size particles; Nano-fibers – nanometer (nm) siz...

the use of an inorganic phase in water-in-oil (w/o) microemulsion   has   received considerable attention recently for preparing metal oxide   nanoparticles. this is a technique, which allows preparation of ultrafine   metal oxide nanoparticles within the size range 40 to 80 nm. preparation of   nano zno and cr 2 o 3 studied, investigated in the inverse   microemulsion system. therefore the nuc...

Increased production of industrial devices constructed with nanostructured materials raises the possibility of environmental and occupational human exposure with consequent adverse health effects. Ultrafine (nano) particles are suspected of having increased toxicity due to their size characteristics that serve as carrier transports. For this reason, it is critical to refine and improve existing...