In the current research, thermal conductivity of magnetite (Fe3O4) has been calculated using molecular dynamic simulation. The rNEMD Molecular Dynamics Method provided in the LMMPS package is used for the simulation of the thermal conductivity. The effects of magnetite layer size and temperature on the thermal conductivity have been investigated. The numerical results have...

The relationships between thermal conductivity and other petrophysical properties have been analysed for a borehole drilled in a Tertiary Flysch sequence. We establish equations that permit us to predict rock thermal conductivity from logging data. A regression analysis of thermal conductivity, bulk density, and sonic velocity yields thermal conductivity with an average accuracy of better than ...

To minimize the lattice thermal conductivity in thermoelectrics, strategies typically focus on the scattering of low-frequency phonons by interfaces and high-frequency phonons by point defects. In addition, scattering of mid-frequency phonons by dense dislocations, localized at the grain boundaries, has been shown to reduce the lattice thermal conductivity and improve the thermoelectric perform...

Correction for 'Decrease in thermal conductivity in polymeric P3HT nanowires by size-reduction induced by crystal orientation: new approaches towards thermal transport engineering of organic materials' by Miguel Muñoz Rojo et al., Nanoscale, 2014, 6, 7858-7865.

In this paper, the anisotropic thermal conductivity characteristics of graphene wrinkles are observed for the first time using a non-equilibrium molecular dynamics method. Our results reveal that the wrinkling level has little effect on the thermal conductivity along the wrinkling direction. However, the wrinkling level plays an important role in the reduction of thermal conductivity along the ...

We study the nonequilibrium state of heat conduction in a one-dimensional system of hard point particles of unequal masses interacting through elastic collisions. A BBGKY-type formulation is presented and some exact results are obtained from it. Extensive numerical simulations for the two-mass problem indicate that, even for arbitrarily small mass differences, a nontrivial steady state is obtai...

We report the first experimental results on the temperature dependent in-plane and cross-plane thermal conductivities of a symmetrically strained Si/Ge superlattice and a Ge quantum-dot superlattice measured by the two-wire 3 omega method. The measured thermal conductivity values are highly anisotropic and are significantly reduced compared to the bulk thermal conductivity of the structures. Th...

The resistance of metals is a function of applied pressure, and this dependence is large enough to be significant in the calibration of transient hot-wire thermal conductivity instruments. We recommend that for the highest possible accuracy, the instrument's hot wires should be calibrated in situ. If this is not possible, we recommend that a value of γ, the relative resistance change with press...

New experimental data on the thermal conductivity of 2,3,3,3-tetrafluoroprop-1-ene (R1234yf) and trans-1,3,3, 3-tetrafluoropropene (R1234ze(E)) are reported that allow the development of wide-range correlations. These new experimental data, covering a temperature range of (242 to 344) K for R1234yf and (203 to 344) K for R1234ze(E) at a pressure range of (0.1 to 23) MPa, are used to develop cor...

In one and two dimensions, transport coefficients may diverge in the thermodynamic limit due to long-time correlation of the corresponding currents. The effective asymptotic behavior is addressed with reference to the problem of heat transport in one-dimensional crystals, modeled by chains of classical nonlinear oscillators. Extensive accurate equilibrium and nonequilibrium numerical simulation...