Under the excitation of geomagnetic field, normal component of surface scattering magnetic field intensity Hp(y) changes of steel tensile samples with different stress concentration factors α were studied. Constant amplitude sinusoidal tensile load cycles were applied on 18CrNi4A steel plate samples whose α were respectively 1, 3 and 5. Then the correlation of Hp(y) value changes with loading c...

An electroplating spring-bridge micro-tensile specimen is fabricated to carry out a series of monotonic tensile testing on it. Freestanding thin films were loaded by performing monotonic loading/unloading and tensiontension fatigue experiments. Loading was applied using a piezoelectric actuator with 0.1 μm resolution connected through pin hole into the test chip specimen. Loads were measured by...

It is believed that the failure mode of metal nanowires under tensile loading is the result of the nucleation and propagation of dislocations. Such failure modes can be slip, partial slip or twinning and therefore they are regarded as local deformation. Here we provide numerical and theoretical evidences to show that global deformation is another predominant failure mode of nanowires under tens...

M ODERN dental practice makes wide use of precious metal alloys in wire form as partial denture clasps and as orthodontic appliances. When used in such applications, these alloys are subject only to bend loading and never to pure tensile loading. For this reason, there has long been a feeling within the dental profession that the tensile test for wires was somewhat inappropriate and might be re...

Mechanical response of E-glass/epoxy fiber reinforced composite was investigated in tensile loading. Different types of tabs were considered in order to evaluate their effects on the tensile strength of material. Specifically, two types of molded tabs and five types of bonded tabs were considered in the study. The influence of different amount of gripping pressures on failure mode and on tensil...

Metallic glass (MG) generally fails in a brittle manner under uniaxial tension loading at room temperature. The lack of plastic strain of MG is due to the severe plastic instability via the easily formed one dominate shear band. There have been several approaches to improve the ductility in MG, but achieving uniform tensile ductility for monolithic MG in bulk size remains a challenge. Here we d...

Time reversal active sensing using Lamb waves is investigated for health monitoring of a composite structure. In the present work experiments were conducted on a glass/epoxy composite plates to study the time reversal behavior of A0 and S0 Lamb wave modes. PZT wafer sensors were surface bonded to the structure for generation and reception of the Lamb wave modes. Time reversal experiments were f...

The fatigue behavior of a Ceramic Matrix Composite (CMC) at intermediate temperature under air is investigated. Because of the low density and the high tensile strength of CMC, they offer a good technical solution to design aeronautical structural components. The aim of the present study is to compare the behavior of this composite under static and cyclic loading. Comparison between incremental...

This paper describes the non-uniform corrosion characteristics and mechanical properties of reinforcement under coupled action of carbonation and static loading. The two parameters, namely area-box (AB) value and arithmetical mean deviation (Ra), are adopted to characterize the corrosion morphology and pitting distribution from experimental observations. The results show that the static loading...

Deformation mechanisms of as-deposited and post-annealed Ti50.2Ni49.6, Ti50.3Ni46.2Cu3.5 and Ti48.5Ni40.8Cu7.5 thin films were investigated using the in situ synchrotron X-ray diffraction technique. Results showed that initial crystalline phases determined the deformation mechanisms of all the films during tensile loading. For the films dominated by monoclinic martensites (B19'), tensile stress...