Flexible intramedullary nails are commonly used to treat femoral fractures in children. This study evaluated the biomechanical differences between stainless steel and titanium nails when securing transverse and comminuted fractures in a synthetic femur model. Retrograde flexible stainless steel and titanium nails placed in a divergent "C" pattern were mechanically tested, and axial rotation and...

The advancement of transmission electron microscopy has made it possible to analyze the metallographic structure of steel products on a nanoscopic scale, which leads to the detail understanding of microstructures such as fine precipitates and grain boundaries. The application of the characteristic technology to commercial steel products requires consistency in the structural analysis of steel f...

This paper presents a study to evaluate the mechanical properties of commercially available GRP composite fasteners for the fairing band assembly components of the hull mounted sonar domes on Canadian frigates. The study was undertaken as part of an effort to develop an all-composite fairing band assembly for a stainless steel sonar dome, to eliminate corrosion problems that occur with the use ...

Initiation of corrosion on reinforcing bars occurs when a critical chloride concentration is achieved. A universal value for the chloride concentration that causes depassivation has not been agreed upon for carbon steels due to a variety of experimental factors. The chloride threshold depends on the rebar material, rebar surface condition, testing environment, method of detection, definition of...

Introduction: During sliding mechanics, frictional resistance is an important counterforce to orthodontic tooth movement; which must be controlled to allow application of light continuous forces. objective: To investigate static and kinetic frictional resistance between three orthodontic brackets: ceramic, self-ligating, and stainless steel, and three 0.019×0.025” archwires: stainless steel, ni...

A self-developed rotary multi-cutter device cuts stainless steel wire ropes into segments to fabricate twisted wires. Stainless steel porous twisted wire materials (PTWMs) with a spatial composite intertexture structure are produced by the compaction and subsequent vacuum solid-phase sintering of twisted wires. The stainless steel PTWMs show two types of typical uniaxial tensile failure modes, ...

We report a computational 'alloy by design' approach which can significantly accelerate the design process and substantially reduce the development costs. This approach allows simultaneously optimization of alloy composition and heat treatment parameters based on the integration of thermodynamic, thermo-kinetics and a genetic algorithm optimization route. Novel steel compositions and associated...

The effect of microstructural refinement and intercritical annealing on the mechanical properties and work-hardening response of a low carbon St12 steel was studied. It was revealed that intercritical annealing of the ferritic-pearlitic sheet results in the formation of a coarse-grained DP microstructure with discrete martensite islands normally formed in place of pearlitic colonies, which resu...