OBJECTIVES To evaluate and compare the flexural strength and the elastic moduli of three provisional crown materials (methyl methacrylate based autopolymerized resin, bis acryl composite based autopolymerized resin and urethane dimethacrylate based light polymerized resin) after storing in artificial saliva and testing at intervals of 24 hours and 7 days. STUDY DESIGN A metal master mould wit...

PURPOSE The aim of this study was to compare the flexural strength of polymethyl methacrylate (PMMA) and bis-acryl composite resin reinforced with polyethylene and glass fibers. MATERIALS AND METHODS Three groups of rectangular test specimens (n = 15) of each of the two resin/fiber reinforcement were prepared for flexural strength test and unreinforced group served as the control. Specimens w...

objectives: composite repair is a minimally invasive and conservative approach. this study aimed to evaluate the effect of an additional hydrophobic resin layer on the repair shear bond strength of a silorane-based composite repaired with silorane or methacrylate-based composite. materials and methods: sixty bar-shaped composite blocks were fabricated and stored in saline for 72 hours. the surf...

Objectives Acrylic resins are one of the most important denture base materials in dentistry due to their favourable mechanical and physical properties. The purpose of present study is to compare 4 available acrylic flexural strength properties before and after thermocycling. Methods Acrylic resin specimens of Meliodent (Heraeus Kulzer, Hanau, Germany), Vertex (Vertex-dental BV, Zeist, Netherla...

adequate bond strength between glass ionomer cements and composite resin is necessary for the success of the sandwich technique.this study assessed the micro-shear bond strength of composite resin to glass-ionomer cements (gic) using self-etch adhesives with different ph values.one hundred specimens (6×4×2 mm) were made using fuji ii and fuji ii lc gics and treated with different adhesives as f...

PURPOSE Over the past years, the adhesion of fiber posts luted with simplified adhesive systems has been a matter of great interest. The aim of this study was to assess the post retentive potential of a self-adhesive resin cement using different adhesive systems to compare the push-out bond strengths of fiber posts. MATERIALS AND METHODS The post spaces of 56 mandibular premolar roots were pr...

This study was conducted to clarify the influence of dentin surface moisture on bond strength of single-step self-etch adhesive systems. The adhesive systems used were Adper Prompt L-Pop (AP), Clearfil tri-S Bond (CT), Fluoro Bond Shake One (FB), G-Bond (GB), and One-Up Bond F Plus (OF). Bovine mandibular incisors were wet-ground with #600 SiC to expose the labial dentin. After rinsing with tap...

Purpose: The purpose of this study was to determine the influence of silicone remover on tensile bond strength of eight silicone-resilient denture liners to a denture base resin. Durability of bond strength of resilient denture liner to denture base resin was also examined by thermal cycling test. Materials and Methods: Eight commercial silicone resilient denture liners were used. The specimens...

INTRODUCTION The aim of the study is to evaluate interfacial bond strength between silicone prosthetic elastomers and polymethylmethacrylate (PMMA). MATERIALS AND METHODS Silicone elastomers were attached to PMMA and a total 120 specimens were fabricated which were then subdivided into 12 sub-groups. Each sample was then subjected to laboratory test to determine the bond strength. The specime...

The purpose of this study was to evaluate the correlation between the hybrid layer thickness, resin tag length and resin bond strength of a self-etching adhesive system to sound dentin tissue "in vivo". After performing restorative procedures and tooth extractions, ten specimens were sectioned in a mesiodistal direction. One dental section was used for light microscope analysis, in which both t...