In this study, the effect of temperature on the diffusion welding of AZ31 magnesium alloy and 7075 aluminum was discussed. Diffusion welding temperature was the most important parameter since all mechanisms are sensitive to temperature in Diffusion welding method. Intrusive contacts between the two alloys at temperatures of 430, and 440 °C 450 and took 60 min. In all tests constant pressure and...

The present study was undertaken to investigate the effect of aging parameters (time and temperature) on the mechanical properties of Be-and/or Zrtreated Al-Mg-Zn (7075) alloys. Ultimate tensile strength, 0.5% offset yield strength and % elongation measurements were carried out on specimens prepared from cast and heat treated 7075 alloys containing Be and/or Zr. Different aging treatment were c...

The overall objective of this work was to demonstrate feasibility of adaptive nonlinear signal processing techniques applied to characterization of ultrasonic nondestructive testing (UNDT) waveforms for accurate inferences of flat -bottom hole sizes. The classified waveforms were ultrasonic pulse echoes obtained from two different sets of 7075-T6 aluminum area-amplitude test blocks and three di...

Keywords: AL7075-T6 alloy Ti–TiN coating PVD magnetron sputtering Surface roughness Fuzzy logic Fretting fatigue a b s t r a c t In this study, the fretting fatigue resistance of AL7075-T6 alloy is investigated using surface treatment Ti–TiN multilayer coating by physical vapor deposition (PVD) magnetron sputtering technique. A fuzzy logic model was established to forecast the surface roughness...

In this study, the effect of temperature on the diffusion welding of AZ31 magnesium alloy and 7075 aluminum was discussed. Diffusion welding temperature was the most important parameter since all mechanisms are sensitive to temperature in Diffusion welding method. Intrusive contacts between the two alloys at temperatures of 430, and 440 °C 450 and took 60 min. In all tests constant pressure and...

The inhibition mechanism of sodium oleate (C17H33COONa) for pitting corrosion of aluminum alloy (AA) 2024 in 0.1 mol L NaCl solution was investigated using potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), scanning electron microscopy with energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS). C17H33COONa showed good inhibition effect on u...

Water-soluble metal working fluids are used for processing of aluminum alloy materials. This short paper describes properties of new additives for water-soluble cutting fluids for aluminum alloy materials. Some alkyldiphosphonic acids were prepared with known method. Amine salts of these phosphonic acids showed anti-corrosion property for aluminum alloy materials. However, they have no hard wat...

Shot peening technologies can improve the performance of materials and extend service life parts. Cavitation water jet (CWJP) is a new shot technology that uses shear effect high-speed in submerged environment to produce cluster bubbles, thereby achieving significant increase impact performance. In this paper, CWJP was used strengthen surface 7075 aluminum alloy (Al7075), effects with different...

The viscoelastic response of commercial aluminum alloys 7075-T6 and 2024-T3 as a function of temperature is presented. Experimental data are obtained with a dynamic-mechanical analyzer (DMA) at different loading frequencies and compared with the available transmission electron microscopy (TEM) and differential scanning calorimetry (DSC) data. The effect of successive microstructural transformat...