Creep polycrystalline ice samples antifreeze glycopeptides re-accelerating or tertiary samples. Previous work grain-boundary migration consistent with this, as nucleation and growth of curves containing (AFGPs) creep that has shown obtained from the low concentrations of do not show the is found in pure ice that AFGPs inhibit in ice and the present results are tertiary creep is associated with ...

This paper deals with the effect of drying as a moisture diffusion process in a segment of a typical box-girder bridge. Pore relative humidity distributions throughout the cross sections of the plates of the girder are calculated from the diffusion equation, taking its nonlinearity and aging into account. The effect of creep with aging on the stresses produced by drying shrinkage is taken into ...

Creep performance of zinc borate-treated strandboard from southern pine (Pinus taeda L.) and red oak (Quercus falcata) was investigated at 25°C temperature and 65% relative humidity. It was shown that the borate treatment had some signifi cant effect on creep defl ection of the test panels, and the effect varied with wood species. There was no signifi cant effect of creep loading on residual be...

In-situ neutron diffraction measurements were performed on monocrystalline samples of the Ni-based superalloy CMSX-4 during N-type g0 raft formation under the tensile creep conditions of 1150 C/ 100 MPa, and subsequently on a rafted sample under the low temperature/high stress creep conditions of 715 C/825 MPa. During 1150 C/100 MPa creep, the g0 volume fraction decreased from ~70% to ~50%, the...

The tail tendons from wallabies (Macropus rufogriseus) suffer creep rupture at stresses of 10 MPa or above, whereas their yield stress in a dynamic test is about 144 MPa. At stresses between 20 and 80 MPa, the time-to-rupture decreases exponentially with stress, but at 10 MPa, the lifetime is well above this exponential. For comparison, the stress on a wallaby tail tendon, when its muscle contr...

In Exp. 1, 54 sows (PIC Line 1050) and their litters were used to determine the effects of creep feeding duration on the proportion of pigs consuming creep feed and preweaning performance. Two groups of sows were blocked according to parity and date of farrowing and allotted to 3 experimental treatments in a randomized complete block design. Creep feeding was initiated at d 7, 14, and 18 from b...

The stress analysis of pressurized circumferential pipe weldments under steady state creep is considered. The creep response of the material is governed by Norton’s law. Numerical and analytical solutions are obtained by means of perturbation method, the unperturbed solution corresponds to the stress field in a homogeneous pipe. The correction terms are treated as stresses defined with the help...

The exact prediction of creep is of great significance for the simulation of the stress field of concrete creep. To overcome the limitation of the current prediction model of creep, pertinent models abroad are referred and adopted so that other factors can be controlled under standard state but only the creep varies to evaluate the feasibility of the prediction model with current characteristic...

ÐThe longitudinal primary creep of long-®ber composites is modeled by considering the transient stress states arising from load transfer from the weaker matrix phase to the stronger ®ber phase as the composite transitions from the elastic state present immediately after loading to steady-state stage where both phases creep. The e€ect of primary creep of each of the phases on the primary creep o...