-A dc-dc converter has its applications, such as in hybrid vehicles, solar inverters, in power supplies for microprocessors etc. A bidirectional dc-dc converter can be alternately operated as a step down converter in one direction of energy flow and as step up converter in reverse direction of energy flow, in places where both the sides have voltage sources. A high voltage supply using a single...

This paper presents a modified nine switch inverter with two inputs and two Z-source networks. This inverter has two DC inputs and two AC outputs. Input DC voltages can be boosted to the required level. Amplitude, frequency and phase of AC output voltages can be controlled, independently. The proposed converter can be used in applications with two unregulated DC sources, which require feeding ...

A zero-voltage, zero-current switching (ZVZCS) PWM DC-DC power converter with secondary active rectifier tested as a dc current source for arc welding is described in this paper. The soft switching DC-DC converter consists of high frequency inverter, high frequency power transformer and controlled output rectifier with new secondary energy recovery turn-off snubber. Circulating current in the c...

Abstract—The power buck converter is the most widely used DC/DC converter topology. They have a very large application area such as DC motor drives, photovoltaic power system which require fast transient responses and high efficiency over a wide range of load current. This work proposes, the modelling of DC/DC power buck converter using state-space averaging method and the current-mode control ...

The challenge for distributed power supply engineers is to design a fast switching DC-DC converter with improved transient response, while still maintaining or increasing efficiency. This has to be achieved in the tight thermal envelope required for reliable system operation and at minimal cost. This paper discusses the use of 20V MOSFETs or the economical design of high efficiency DC-DC conver...

DC-DC power converters with multiple inputs and a single output are used in numerous applications where multiple sources, e.g., two or more renewable energy sources and/or a battery, feed a single load. In this work a classical boost converter topology with two input branches connected to two different sources is chosen, with each branch independently being controlled by a separate peak current...

This study proposes and implements maximum power Point Tracking (MPPT) control on thermoelectric generation system using an extremum seeking control (ESC) algorithm. The MPPT is applied to guarantee maximum power extraction from the TEG system. The work has been carried out through modelling of thermoelectric generator/dc-dc converter system using Matlab/Simulink. The effectiveness of ESC techn...

Linear-assisted DC/DC converters are structures that allow to take advantages of the two classic alternatives in the design of power supply systems: Voltage linear regulators (classic NPN topology or LDO –low dropout–) and switching DC/DC converters. This paper shows the proposal of a modified currentmode one-cycle control for linear-assisted DC/DC converters. The modified current-mode one-cycl...

This paper describes the modeling and control of a three-phase grid-connected converter fed by a photovoltaic array. The converter is composed of an isolated DC-DC converter and a three-phase DC-AC voltage source inverter The converters are modeled in order to obtain small-signal transfer functions that are used in the design of three closed-loop controllers: for the output voltage of the PV ar...

A novel integrated single-inductor dual-output (SIDO) buck converter with peak current common-mode and the two output voltage ripples comparison differential-mode control method in continuous conduction mode is presented. The system can use only one inductor to provide two independent output voltages, 1.2V and 1.8V, with a maximum total output current 460mA. The proposed converter has been fabr...