In this paper, xCuO/CeO2–γAl2O3 nano-catalysts were successfully synthesized by precipitation from an aqueous solution which modified via ultrasonic waves. For characterization of xCuO/CeO2–γAl2O3 samples N2 adsorption results showed that the BET surface area of the CuO/CeO2–γAl2O3, X-ray diffraction (XRD), scanning electron microscope (SEM) and energy dispersive X-rays (EDX dot-mapping) were u...

Platinum catalysts supported on carbon xerogel and carbon black (Vulcan) were synthesized with the aim of investigating the influence of the characteristics of the support on the electrochemical performance of the catalysts. Three synthesis methods were compared: an impregnation method with two different reducing agents, sodium borohydride and formic acid, and a microemulsion method, in order t...

Ceria-based gold catalysts were successfully deposited on ferritic stainless steel (Fecralloy) and aluminium monoliths. The prepared monolithic and reference powder catalysts were characterized by means of SBET, X-ray diffraction, glow discharge optical emission spectroscopy and scanning electron microscopy–energy dispersive X-ray analysis techniques and tested in the CO oxidation reaction. Cha...

The paper relates to a catalyst, comprising copperchromium spinel, coated on carrier γ-Al2O3. The effect of preparation conditions on the active component composition and activity behavior of the catalysts is discussed. It was found that the activity of carbon monoxide, DME, formaldehyde and methanol oxidation reaches a maximum at an active component content of 20 – 30 wt. %. Temperature calcin...

Efficient catalysts are crucial for the sustainable generation of fuel by splitting water. A versatile screening protocol would simplify the identification of novel and better catalysts by using high throughput experimentation. Herein, such a screening approach for the identification of molecular catalysts for chemical oxidation of water is reported, which is based on oxygen-sensitive fluoresce...

Palladium nanoparticles supported on carbon black powder (Vulcan XC-72) nanocomposite (Pd/C) are synthesized as the catalyst for the anodic oxidation of glucose for use in a direct glucose alkaline fuel cell (DGAFC). Characterization of the catalyst is carried out using physical and electrochemical methods. It is observed that Palladium nanoparticles are uniformly dispersed onto the carbon blac...

This paper studies oxidation catalytic converters that were vehicle-aged in a diesel automobile. The deposition of several atoms (S, P, C, Si, Ca, Zn and Fe) was detected by several chemical analysis techniques. Moreover, AlPO4 and Al2(SO4)3 were identified by XRD. The catalytic performance of the aged catalysts with different mileages showed a similar degree of deactivation for CO and C3H6 oxi...

New Co-Schiff base complexes that incorporate a sterically hindered ligand and an intramolecular bulky piperazine base in close proximity to the Co center are synthesized. Their utility as catalysts for the oxidation of para-substituted lignin model phenols with molecular oxygen is examined. Syringyl and guaiacyl alcohol, as models of S and G units in lignin, are oxidized in good yield using a ...

The total oxidation of toluene at a wide temperature range (200–500 oC) over micro/mesoporous platinated catalysts has been investigated about activity, selectivity to CO2 and CO, catalyst's stability versus coke deposition and reaction kinetics. Kinetic of toluene oxidation was measured under various oxygen and toluene pressures and als...

A new preparative route for vanadium phosphate catalysts is described using supercritical CO2 as an antisolvent. The amorphous microspheroidal VPO produced is shown to be more active than comparable crystalline VPO catalysts for the selective oxidation of n-butane to maleic anhydride and, furthermore, does not require an extensive pre-treatment or activation period to establish full catalytic a...