This paper presents a review of the major fatigue models and life time prediction methodologies for fibrereinforced polymer composites, subjected to fatigue loadings. In this review, the fatigue models have been classified in three major categories: fatigue life models, which do not take into account the actual degradation mechanisms but use S-N curves or Goodman-type diagrams and introduce som...

this study compared the push-out bond strength of endosequence root repair material (errm) and bioaggregate (ba), new bioceramic materials, to that of mineral trioxide aggregate (mta) after incubation in phosphate-buffered saline (pbs), a synthetic tissue fluid, for either 1 week or 2 months.one-hundred and twenty root sections were filled with proroot mta, ba, or errm. each tested material was...

The reason of this study is low cycle failure of cast iron cylinder head during the E5 standard durability test. The goal of the present investigation is durability test simulation and low cycle fatigue life evaluation of cast iron cylinder head. With uncouple structural analysis, preloads, thermal and mechanical load and boundary conditions are prescribed to finite element model of the cylinde...

fatigue behavior of a vanadium microalloy steel has been studied in this research. here, microstructure constituents were considered which essentially are dependent on the heat treatment conditions. the results of high cycle fatigue tests revealed that heat treatment procedure and cooling rates have significant effects on fatigue properties. optimal heat treatment cycle of the microalloyed stee...

An overview and status of current activities seeking alternatives to 200 grade 18Ni Steel CVM alloy for cryogenic wind tunnel models is presented. Specific improvements in material selection have been researched including availability, strength, fracture toughness and potential for use in transonic wind tunnel testing. Potential benefits from utilizing damage tolerant life-prediction methods, r...

The reliability and failure modes of molar crowns supported by three different implant-supported designs were tested according to the following groups: group 1, one standard-diameter implant (3.75 mm); group 2, one narrow-diameter implant (3 mm); and group 3, two narrow-diameter implants (3 mm). Loads were applied as mouth-motion cycles using a step-stress accelerated life-testing method. ? val...

Cold-in-place recycling (CIR) is an environmentally sustainable alternative for preservation of asphalt pavements. A major disadvantage of this practice is the lower strength of the cold-in-place mixtures. Addition of cement into this type of mixture is a method for increasing its bearing capacity. The effect of cement content on the mechanical properties of the cold-in-place recycled asphalt m...