The purpose of this study was to evaluate the flexural strength, flexural modulus, modulus of resilience, and water sorption of four flowable light-cured composite resins (FCRs). Results were then compared with four conventional composite resins (CCRs) and a minifilled hybrid light-cured composite resin, which served as a control. Twenty specimens were flexural tested immediately after curing, ...

The dynamic, three-dimensional shape of flapping insect wings may influence many aspects of flight performance. Insect wing deformations during flight are largely passive, and are controlled primarily by the architecture and material properties of the wing. Although many details of wing structure are well understood, the distribution of flexural stiffness in insect wings and its effects on wing...

AIM The purpose of this study was to evaluate and compare the flexural strength of commercially available acrylic (trevalone) and modified polymethylmethacrylate (PMMA). MATERIALS AND METHODS Four groups were tested; Group 1- control group regular MMA, group 2-2% methacrylic acid, 88% MMA, group 3-16% methacrylic acid, 84% MMA group 4- 20% methacrylic acid, 80% MMA 15 resin specimens of each ...

To investigate the propagation of flexural waves in a borehole surrounded by an azimuthally anisotropic hard formation, we made an ultrasonic borehole model of Delabole slate with very strong anisotropy. The axial and azimuthal acoustic fields generated by a dipole source were measured in the fluid-filled borehole. The results show that there are three dominant wave modes: fast and slow flexura...

Copyright © Korean Carbon Society http://carbonlett.org Abstract The use of carbon nanotubes (CNTs) as a reinforcing material in a polymer matrix has increased in various industries. In this study, the flexural behavior of CNT-modified epoxy/ basalt (CNT/epoxy/basalt) composites is investigated. The effects of CNT modification with silane on the flexural properties of CNT/epoxy/basalt composite...

The aim of the present study was to measure various mechanical properties of acrylic denture base resins, including flexural modulus, flexural strength, fracture toughness, Barcol and Vickers hardness and their related properties, and to investigate correlations between different mechanical properties. Resin specimens were prepared according to manufacturers' recommended instructions. The mecha...

Flexural ultrasonic transducers are principally used as proximity sensors and for industrial metrology. Their operation relies on a piezoelectric ceramic to generate a flexing of a metallic membrane, which delivers the ultrasound signal. The performance of flexural ultrasonic transducers has been largely limited to excitation through a short voltage burst signal at a designated mechanical reson...

The addition of different polymers, such as polytetrafluorethylene (PTFE), to denture base resins could be an option to modify acrylic resin mechanical properties. This study evaluated the surface hardness, impact and flexural strength, flexural modulus and peak load of 2 acrylic resins, one subjected to a long and another subjected to a short polymerization cycle, which were prepared with or w...

Objective This study evaluated the flexural strengths of reinforced denture base resins subjected to long-term water immersion. Materials and methods Acrylic denture base resin reinforced with metal wire or glass fiber-reinforced composite (FRC), and without reinforcement were tested. Bar-shaped specimens were fabricated. Half of the specimens were stored in 37 °C distilled water for 50 hours (...

AIM The aim of this in vitro study was to compare the flexural strength, the flexural modulus and compressive strength of the acrylic polymer reinforced with glass, carbon, polyethylene and Kevlar fibres with that of plain unfilled resin. MATERIALS AND METHODS A total of 50 specimens were prepared and divided into 10 specimens each under 5 groups namely group 1- control group without any fibr...