Flow boiling heat transfer with the refrigerants R-134a and R-245fa in copper microchannel cold plate evaporators is investigated. Arrays of microchannels of hydraulic diameter 1.09 mm and 0.54 mm are considered. The aspect ratio of the rectangular cross section of the channels in both test sections is 2.5. The heat transfer coefficient is measured as a function of local thermodynamic vapor qua...

In the present paper, the effect of water-CuO nanofluid on the radiator heat transfer of an automobile, Peugeot 405 XU7 engine type is investigated experimentally. The experiments are carried out for the radiator water (water-ethylene glycol with a volume fraction of 80-20, respectively) as a base fluid and water-CuO nanofluid with the volume fraction of 0.5% and 1%. Sodium Dodecyl Sulfate (SDS...

The heat transfer coefficient value strongly depends on surface temperature rise and cooling fluid velocity. Thus, taking into account that usually large temperature gradients occur in air cooled electronic circuits, the local values of this coefficient might differ substantially throughout circuit outer surfaces. Consequently, the assumption of heat transfer coefficient uniformity for the enti...

This second part of a two-part study concerns heat transfer characteristics for FC-72 condensing along parallel, square micro-channels with a hydraulic diameter of 1 mm, which were formed in the top surface of a solid copper plate. Heat from the condensing flow was rejected to a counter flow of water through channels brazed to the underside of the copper plate. The FC-72 condensation heat trans...

In this paper the steady laminar magneto hydrodynamic (MHD) mixed convection boundary layer flow towards a vertical stretching sheet with variable fluid viscosity, radiation and in the presence of Dufour’s effect have been investigated. The governing partial differential equations are transformed into set of ordinary differential equations using similarity transformation, and then these equatio...

Nomenclature a = stoichiometric coefficient av = surface-to-volume ratio C;, Cb; = surface and bulk concentration, vol % Da = Damkohler number Eif R = activation energy, K F = steady-state function h = heat-transfer coefficient K, = adsorption equilibrium coefficient k, k0 = reaction rate constant and preexponential factor, respectively kc = mass-transfer coefficient l = apparent reaction order...

in this paper, experimentally derived correlations of heat transfer and pressure drop are used in a pareto based multi-objective optimization (moo) approach to find the best possible combinations of heat transfer and pressure drop of tio2-water nanofluid flow in tubes fitted with multiple twisted tape inserts in different arrangement. in this study there are four independent design variables: t...