Background: This study compared the amount of residual cement at margin implant-supported crowns cemented using polytetrafluoroethylene (PTFE) tape, replica technique, and conventional cementation technique. Methods: In this in vitro experimental study, a mandibular model underwent full-arch scanning. The right first molar tooth was eliminated on scan Exocad software, regular implant analog mod...

OBJECTIVES The present study used strain gauge analysis to perform an in vitro evaluation of the effect of axial loading on 3 elements of implant-supported partial fixed prostheses, varying the type of prosthetic cylinder and the loading points. MATERIAL AND METHODS Three internal hexagon implants were linearly embedded in a polyurethane block. Microunit abutments were connected to the implan...

OBJECTIVES An increasing aesthetic demand within developed populations conducted to the fabrication of metal-free restorations and to a wide use of ceramic materials, due to its excellent characteristics of biocompatibility and aesthetics. With the incessant increase of commercial labels involved in this technological advance, a review is imposed on ceramic abutments, specifically on zirconia. ...

PURPOSE: The aim of this study was to evaluate in vitro the microgap between different zirconia abutments and their titanium implants. MATERIALS AND METHODS: Four systems were evaluated: Procera zirconia (Nobel Biocare) (Nb), Cercon Balance Anterior (Dentsply Friadent) (Ba), ZirDesign (Astratech) (Zd), and Straumann Cares ceramic (Straumann) (Ca). Five assemblies were assessed for each system. ...

OBJECTIVE: The purpose of this study was to determine the fracture strength of zirconium implant abutments and the torque required to unfasten the retaining screw before and after applying cyclic loading to the implant-abutment assembly. The dynamic behavior and stress distribution pattern of zirconium abutments were also evaluated. METHODS AND MATERIALS: Static and cyclic loading of 7 XiVE imp...

PURPOSE The purpose of this study was to evaluate the effect of implant abutment material on peri-implant soft tissue color using intraoral spectrophotometric analysis and to compare the clinical outcomes with patient and clinician perception and satisfaction. MATERIALS AND METHODS Thirty patients and four prosthodontic faculty members participated. Abutments were zirconia, gold-hued titanium...

Aim: To evaluate the loss of applied torque (detorque) values in cast and pre-machined abutments for external hex abutment/implant interface of single implant-supported prostheses subjected to mechanical cycling. Methods: Ten metal crowns were fabricated using two types of UCLA abutments: cast and pre-machined with metal base in NiCrTi alloy and tightened to regular external hex implants with a...

PURPOSE The aim of the present study was to evaluate if a smaller morse taper abutment has a negative effect on the fracture resistance of implant-abutment connections under oblique compressive loads compared to a conventional abutment. MATERIALS AND METHODS Twenty morse taper conventional abutments (4.8 mm diameter) and smaller abutments (3.8 mm diameter) were tightened (20 Ncm) to their res...

Objective The study evaluated the influence of abutment design on the retention of implant-cemented metal copings. Material and methods Two abutments of the same system with the same indications, height and the total occlusal convergence, but of different designs were evaluated. Ten RN synOcta abutments (Straumann, Waltham, MA) and ten RN titanium solid abutments (Straumann, Waltham, MA) were t...

BACKGROUND Microleakage through the interface has been documented in implant systems with titanium (Ti) abutments. There is a current increase in the use of zirconia (Zi) abutments especially in esthetic zone in where higher risk of visible metal color through the peri-implant tissues exists. PURPOSE The aim of the present in vitro study is to evaluate the leakage at the implant fixture-abutm...