We report systems for network measurements at millimeter-wave frequencies. Active probes are used for on-wafer measurements to approximately 150 GHz. The active probes incorporate monolithic GaAs mm-wave network analysis circuits (comprising a nonlinear transmission line stimulus signal generator and a directional sampling circuit) and lowloss, rugged quartz coplanar-waveguide probe tips. Wideb...

The principle of recursive filters is well known in digital filtering. This paper deals with active recursive filters. A new design approach is presented. It will be shown that how active elements can be used in the design of amplification elements and large microwave time delay. The analytical and computer-simulated results will be presented for an active bandpass filter in the C-band. Key-Wor...

:mCl Quum INSrnCrnD3 Abstract We have successfully integrated a thermally insulating silica aerogel thin film into a new uncooled monolithic thin film infrared (E) imaging device. Compared to other technologies (bulk ceramic and microbridge), use of an aerogel layer provides superior thermal isolation of the pyroelectric imaging element from the relatively massive heat sinking integrated circui...

PRODUCT DESCRIPTION The AD592 is a two terminal monolithic integrated circuit temperature transducer that provides an output current proportional to absolute temperature. For a wide range of supply voltages the transducer acts as a high impedance temperature dependent current source of 1 μA/K. Improved design and laser wafer trimming of the IC’s thin film resistors allows the AD592 to achieve a...

A monolithic circuit has been designed for active-quenching and active-reset of single-photon avalanche diodes (SPADs), which operate above the breakdown voltage BD for detecting single photons. To the best of our knowledge, this is the first fully integrated circuit of this kind ever reported. It can operate with any available SPAD device, since it generates pulses high enough to quench detect...

The discrete time switched capacitor (SC) based filters have number of advantages over the classical continuous time active RC based filters, the one most important being reduced circuit silicon area, allowing SC filters to be integrated to a single monolithic integrated circuit (IC). In this paper we have designed fifth order Chebyshev low pass SC filter, with a cut-off frequency fc = 3.4 kHz,...

In the post-Moore era, an electrically driven monolithic optoelectronic integrated circuit (OEIC) fabricated from a single material is pursued globally to enable the construction of wafer-scale compact computing systems with powerful processing capabilities and low-power consumption. We report a monolithic plasmonic interconnect circuit (PIC) consisting of a photovoltaic (PV) cascading detector...

Introduction: Optoelectronic circuits with high levels of circuit connectivity and nanosecond time-scale reconfigurability of massively broadband optical signals may play an increasing role in high-capacity data transfer optical networks. Photonic integrated semiconductor optical amplifier (SOA) gate-based circuits have received particular attention owing to the promise of low control complexit...

We report on the development of W-band (75–110 GHz) heterodyne receiver technology for large-format astronomical arrays. The receiver system is designed to be both mass producible, so that the designs could be scaled to thousands of receiver elements, and modular. Most of the receiver functionality is integrated into compact monolithic microwave integrated circuit (MMIC) amplifier-based multich...

In this paper, a frequency reconfigurable circular antenna design and development is proposed for wireless devices. In the proposed design, a circular patch antenna with circular slot using two PIN diodes at the centre frequency 10 GHz was designed and simulated frequency reconfiguration is achieved in the frequency range of 9.69-10.2 GHz and the measured results shows the same effect in the fr...