Air-jet-textured polyester yarns were produced using two feed yarns differing in filament fineness and number of filaments. By varying the yarn overfeed, filament fineness and air pressure, four textured yarns were produced. Woven fabrics were prepared using these textured yarns as weft and cotton yarns in warp. To study the effect of air-jet-texturing parameters on the bending and compression ...

Aalto University, P.O. Box 11000, FI-00076 Aalto www.aalto.fi Author Yi Xiong Name of the doctoral dissertation In-plane Tire Deformation Measurement Using a Multi-Laser Sensor System Publisher School of Engineering Unit Department of Mechanical Engineering Series Aalto University publication series DOCTORAL DISSERTATIONS 89/2016 Field of research Engineering Design and Production Manuscript su...

Trucking fleets and owners of commercial vehicles utilize both new and retread tires on their vehicles in the United States. Retread tires are used primarily for the cost advantage they provide over a similar new tire. Despite the advantages that retreaded tires may bring, public perception is that retread tires are less safe than new tires as evidenced by the amount of tire debris frequently f...

This paper introduces a technique that relates the coefficients of the Magic Formula tire model to the physical properties of the tire. For this purpose, the tire model is developed by ABAQUS commercial software. The output of this model for the lateral tire force is validated by available tire information and then used to identify the tire force properties. The Magic Formula coefficients are o...

While a new tire may have excellent resistance to crack initiation and propagation between the steel belts, an aged tire of the exact same construction can exhibit dramatically reduced crack growth resistance, which in some cases may contribute to tire failure. This article will review the research that has gone into quantifying the rate of oxidation the steel belt rubber oxidizes in different ...

Cord steel is used for making tire frames and wire saws cutting silicon wafers. The diameter of mainstream has been developed to be lower than 100 μm. size deformation ability inclusions are very important the breaking rate cord during drawing process. In order improve in steel, alkali metal oxide was added into molten so as obtain good, plastic, low-melting-point inclusions. Mass fractions 0.3...

in this study, a simulation of tire–soil interaction model was considered with special view to two-dimensional (2-d) fem model of carcass. coefficients of mechanical behavior of silty-loam soil were accurately measured to obtain an effective simulation. the results of simulation which was implemented in matlab7, showed that the radial-ply tire had greater tractive efficiency than bias tire at t...

In this study, a low degree-of-freedom mechanical model of a rolling tire is constructed, in which the lateral deformation of the contact patch and tire carcass is considered. The so-called delayed contact patch model is implemented and combined with a simple tire carcass model. The interaction between the contact patch and the carcass together with the lateral mode of the attached suspension s...

Often when vehicles interact with roadside hardware like guardrails, bridge rails and curbs, the interaction between the roadside hardware and the tire causes the tire to lose its air seal and "blow-out". Once the seal between the rim and rubber tire is lost, the tire deflates. The behavior of the deflated tire is much different than the behavior of an inflated tire such that when this behavior...

The preparation of warp yarn is more demanding and complicated than that of the filling yarn. Each spot in a warp yarn must undergo several thousand cycles of various tensions applied by the weaving machine. In general terms, warping is transferring many yarns from a creel of single-end packages forming a parallel sheet of yarns wound onto a beam or a section beam. In Figure 1 is shown the Sche...