This paper describes a 3-D automated pavement distress data collection and analysis system based on NRC’s Biris sensor technology. The paper introduces the problem to be solved, the selected design criteria, and the adopted solution to monitor the quality of road surfaces. The system geometry for the acquisition of the threedimensional coordinates of pavement surface distresses is presented. Mu...

A B S T R A C T Using a model of a single layered foundation to describe a highway or an airfield pavement and an integral formulation, the problem of a pavement containing on-the-top layer a crack of finite length 2c is solved for the stress distribution around the crack tip. The analysis shows that the stresses possess the usual 1/e 1⁄2 singular behavior which is characteristic of crack probl...

Recently, electromagnetic (EM) wave absorbers had been proposed to improve EM environment of Dedicated Short-Range Communication (DSRC) systems for Electronic Toll Collection (ETC) applications. In this paper, the ray-tracing method, which has been widely used to study the radio wave propagations on terrain profiles, is employed to study EM environment when wave absorbers are installed on the s...

This research assesses the next generation of permeable pavement systems (PPS) incorporating ground source heat pumps (geothermal paving systems). Twelve experimental pilot-scaled pavement systems were assessed for its stormwater treatability in Edinburgh, UK. The relatively high variability of temperatures during the heating and cooling cycle of a ground source heat pump system embedded into t...

Several pavement failures have been observed to be initiated at or near the surface of the hot-mix asphalt layers and some of them propagate downward through the surface layer (top-down cracking). These modes of failure are affected by heavy vehicular loading configuration, pavement structure and their interaction at the tire-pavement contact. This paper documents an experimental investigation ...

Most procedures currently used for the structural and geometric design of pavements fail to treat adequately the effects of mixed traffic on pavement life. The effects of the magpitude$ the configuration, and the number of repetitions of various wheel loads should be included as variables in any good pavement design procedure. An analysis of the axle loads observed on Texas highways is used wit...

Using recycled concrete aggregate (RCA) as base/subbase for road construction is alternative way to manage construction waste and reduces the need for virgin aggregates. This paper discusses the long-term performance of concrete pavements on RCA granular layer in comparison to concrete pavements on virgin aggregate granular layer. 18 representative RCA pavement sections across Iowa were primary...

A potential automated pavement evaluation system to address multisensor applications; integrate different types of sensors , techniques, and information; and offer more sophisticated and intelligent processing capabilities for improved pavement management is described. The separate components of this system either now exist in prototype form or are under development . Such a system could automa...

This investigation discusses the findings on analysis results of a pavement structure constructed on a relatively expansive material consisting mainly of brown clayey silt in Tebessa, Algeria. Cores were brought to the laboratory from a piece of roadwork. Remolded samples were taken from subgrade of a deteriorated road. The soils were generally found to be of medium plasticity and of a medium t...

Pavement condition assessment is essential when developing road network maintenance programs. In practice, pavement sensing is to a large extent automated when regarding highway networks. Municipal roads, however, are predominantly surveyed manually due to the limited amount of expensive inspection vehicles. As part of a research project that proposes an omnipresent passenger vehicle network fo...