The low degree relation for algebraic attacks on E0 combiner given in [1] had an error. The correct version of low degree relation for the E0 combiner for use in algebraic attack is given.

In this paper, an octave bandwidth Doherty power amplifier (DPA) using a novel combiner is presented. The fundamental bandwidth limitation of the load modulation concept of a conventional Doherty structure is solved based on the proposed combination method. For verification, an octave bandwidth asymmetric Doherty architecture is implemented by using gallium-nitride (GaN) HEMT Cree CGH40010 and ...

Introduction: Coupling between coil elements of a transmit array is one of the key challenges faced by designers of MRI transmitter arrays. To address this challenge, methods and systems have been developed to change the output impedance of the RF power amplifiers driving the array coils in order to suppress inter-element coupling effects. Chu [1], for example, proposed an output-matching netwo...

This paper describes the Thermal and structural combined simulation on COMSOL Multiphysics of a Microwave (MW) Fin Taper (FT) Spatial Power Combiner (SPC) Power Amplifier (PA), based on rectangular Waveguide (WG). In the SPC based PA's, the captured power is feeded by microstrip transmission lines (μSTL’s) to Monolithic Microwave Integrated Circuit (MMIC) Solid State Power Amplifier (SSPA’s). T...

In this paper, we report the latest progress of a GaN-based broad-band power amplifier using AlGaN/GaN high electron mobility transistors (HEMTs), grown on sapphire substrates, as the active devices. The devices were flip-chip integrated onto the aluminum nitride circuit board for thermal management and electric connection. The circuit topology used novel -matching networks in a four-way binary...

In this paper, we present new results in the development of a broad-band spatial power-combining system implemented in a standard X-band waveguide environment. Using 24 off-the-shelf GaAs monolithic-microwave integrated-circuit (MMIC) power amplifiers integrated with tapered-slot antenna arrays, the new combining circuit produced up to 126-W maximum power output with a gain variation of 1.9 dB ...

The use of massive multiple-input multiple-output (MIMO) techniques for communication at millimeter-Wave (mmW) frequency bands has become a key enabler to meet the data rate demands of the upcoming fifth generation (5G) cellular systems. In particular, analog and hybrid beamforming solutions are receiving increasing attention as less expensive and more power efficient alternatives to fully digi...