http://dx.doi.org/10.1016/j.measurement.2016.04.027 0263-2241/ 2016 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/). ⇑ Corresponding author at: Department of Electronics, Mathematics and Natural Sciences, University of Gävle, SE-801 76 Gävle, Sweden. E-mail address: [email protected] (...

conclusions radiofrequency ablation may be used successfully in the treatment of parathyroid adenoma when a patient cannot tolerate surgery. case presentation a 47-year-old patient was referred to our hospital (namazi hospital, shiraz, iran) in april, 2015 with intracranial hemorrhage, as well as high serum calcium and pth (parathyroid hormone) levels (12.1 mg/dl and 1062 pg/ml, respectively), ...

physical agents such as ultraviolet or ionizing radiation and repetitive trauma have been related to the causation of cancer in humans. much less clear is the association between exposure to radiofrequency, such as radar and microwave radiation to the development of cancer. sporadic case reports and small series suggest that this type of radiation might lead to cancer or contribute to its evolu...

This report describes the development of a transimpedance amplifier that takes current as input and gives voltage as output. The amplifier consists of three CMOS amplifier stages in a fed-back configuration, achieving a transimpedance gain over 3 kΩ and a 3-dB bandwidth greater than 2.8 GHz. The amplifier operates with a 1.5 V supply voltage and a power budget of 30 mW.

The main difference in topology of a boost bridgeamplifier and state-of-the-art class-D amplifier is in theconnection of a loudspeaker between a power supply and aswitching bridge. The boost bridge amplifier provides fourtimes higher peak power at the loudspeaker than the power,which can be achieved by a class-D amplifier from the samepower supply. Total harmonic distort...

We have developed a large-aperture, flash-lamp-pumped Cr:LiSrAlF(6) (Cr:LiSAF) amplifier for use in a femtosecond chirped-pulse amplifier system. Optimum design of the 19-mm-diameter amplifier results in a single-pass gain of 5 with good beam quality. This amplifier produces 1.05-J pulses after compression, with a width of 125 fs at a repetition rate of 0.05 Hz.

In this paper, we have developed a high power solid-state power amplifier (SSPA) for Sband military radars. The SSPA consists of a high power amplifier (HPA) module combined GaN based power amplifier pallets, a drive amplifier (DA) module, a digital control module and a power supply unit. The SSPA shows the total output power of 62 dBm in S-band.

Large bit-line capacitance is one of the main bottlenecks to the performance of on-chip caches. New sense amplifier techniques need to explicitly address this challenge. This paper describes two sensing techniques to overcome this problem: a current sense amplifier (CSA) and a charge transfer sense amplifier (CTSA) and their implementation based on 90nm CMOS technology. The current sense amplif...

Analysis and simulation are presented of the mismatched load condition for a balanced class-E power amplifier, which is based on 90° hybrids at its input and output. The performances of the 200-Watt balanced class-E amplifier, such as the output power and efficiency, were analyzed and compared to the conventional single-ended class-E power amplifier for the 1:3 VSWR mismatch condition. The simu...

introduction: one of the minimally invasive methods of treatmenting liver malignancies is radiofrequency ablation (rfa) which can be applied to primary or secondary tumors. nevertheless, the disease recurrence is probable after rfa application partially due to the inadequate capability of temperature monitoring of the target tissue and visualizing the thermal damage. the goal of this work was t...