A physically based elasto-visco-plastic constitutive model is presented and compared to experimental results for a DD14 mild steel. The model requires significantly fewer material parameters compared to other visco-plasticity models from the literature while exhibiting very good accuracy. Accordingly, the parameter identification is simple and intuitive, requiring a relatively small set of expe...

Modeling fuel behavior requires an accurate description of the cladding stress response for both operational and safety considerations. The transient creep response of Zirconium alloys is commonly modeled using a strain hardening rule which is known to hold in cases with monotonously increasing stresses. However, the strain hardening rule is experimentally known to fail in scenarios such as loa...

Shear instabilities in the form of shear bands are often observed during high speed, plastic deformations of metals. According to one theory, their formation is attributed to eeective strain-softening response, which results, at high strain rates, as the net outcome of the innuence of thermal softening on the, normally, strain-hardening response of metals. In order to test the core instability ...

To investigate the hot deformation behavior of 17-7 PH stainless steel, hot compression tests were carried out at the temperatures of 950, 1050 and 1150 oC and strain rates of 0.001 s-1 to 0.1 s-1. Accordingly, the hot working behavior was studied by the analyses of flow stress curves, work hardening rate versus stress curves, exponent- type constitutive equations and deformed microstructures. ...

A phenomenological theory is presented for describing the anisotropic plastic flow of orthotropic polycrystalline aluminum sheet metals under plane stress. The theory uses a stress exponent, a rate-dependent effective flow strength function, and five anisotropic material functions to specify a flowpotential, an associated flow rule of plastic strain rates, a flow rule of plastic spin, and an ev...

The data presented in this article are related to the research article entitled "On the plasticity mechanisms of lath martensitic steel" (Jo et al., 2017) [1]. The strain hardening behavior during tensile deformation of a lath martensitic press hardening steel was described using a dislocation density-based constitutive model. The Kubin-Estrin model was used to describe strain hardening of the ...

A constitutive multi-laminate based elastic-plastic model developed to be capable of accounting induced anisotropic behavior of granular material such as sand. The fabric feature or grain orientation characteristic effects through medium are considered in a rational way under any complex stress path, including cyclic loading. The salient feature of the developed model is a non-associative on pl...

[1] Differential stresses in a cylindrical rock of polycrystalline Mg2SiO4 ringwoodite were measured at room temperature with pressures up to 10 GPa, axial strains in excess of 20%, and strain rates between 5 10 5 and 4 10 6 s , using the deformation-DIA coupled with monochromatic X-rays. The sample exhibited ductile behavior in axial shortening-lengthening cycles with reproducible hysteresis l...

By analyzing the problem of high pressure torsion (HPT) in the rigid plastic formulation, we show that the power hardening law of plastically deformed materials leads to self-similarity of HPT, admitting a simple mathematical description of the process. The analysis shows that the main parameters of HPT are proportional to β q , with β being the angle of the anvil rotation. The meaning of the p...