In this paper, the axial stress and deformation of high temperature high pressure super-deep deviated gas wells are studied. A new model presents multiple nonlinear equation systems, which comprehensively consider the axial load of the tubular string, internal and external fluid pressure, normal pressure between the tube and well wall, friction and the viscous friction of fluid flowing under va...

Energy consumption and tribological properties could be improved by proper design of surface texture in friction. However, some literature focused on investigating their performance under high temperature. In the study, different groove surface textures were fabricated on steels by a laser machine, and their tribological behaviors were experimentally studied with the employment of the friction ...

The paper presents a combined experimental and theoretical approach to the understanding of hysteresis and adhesion contributions to rubber friction on dry and lubricated rough surfaces. Based on a proper analysis of the temperature- and frequency-dependent behaviors of nonlinear viscoelastic materials such as filler reinforced elastomer materials, master curves for the viscoelastic moduli are ...

Sea ice contains flaws including frictional contacts. We aim to describe quantitatively the mechanics of those contacts, providing local physics for geophysical models. With a focus on the internal friction of ice, we review standard micro-mechanical models of friction. The solid’s deformation under normal load may be ductile or elastic. The shear failure of the contact may be by ductile flow, ...

Measurements of nanoscale friction between silicon AFM tips featuring an in-situ solid state heater and silicon substrates (both with native oxide) were performed. The temperature of the heater was varied between room temperature and approximately 650 °C. For these temperatures and the silicon substrate, the temperatures at the point of contact are estimated to range from room temperature to ap...

The wear of ultrahigh molecular weight polyethylene (UHMWPE) is considered as one of the major reasons for revision of artificial joints. While in vivo measurements have shown a significant temperature increase in knee implants, the amount of heat dissipated within the UHMWPE tibial component and its influence on the friction behavior when paired with a cobalt-chromium (CoCrMo) femoral componen...

Due to the poor conditions of wet brake cooling and the high temperature of the working characteristics, this paper intended to introduce the oil film vadose between the brake linings, considered the variation of volume of grooves on the friction plate, and then proposes the three-dimensional transient dynamic response of fluid-solid coupling mathematical model. By parameter analysis of the dis...

Our aim was to elucidate the physical background of internal friction of enzyme reactions by investigating the temperature dependence of internal viscosity. By rapid transient kinetic methods, we directly measured the rate constant of trypsin 4 activation, which is an interdomain conformational rearrangement, as a function of temperature and solvent viscosity. We found that the apparent interna...

Flat plate skin friction calculations over a range of Mach numbers from 0.4 to 3.5 at Reynolds numbers from 16 million to 492 million using a Navier Stokes method with advanced turbulence modeling are compared with incompressible skin friction coefficient correlations. The semi-empirical correlation theories of van Driest; Cope; Winkler and Cha; and Sommer and Short T’ are used to transform the...

Effects of some thermo-physical parameters on free convective heat and mass transfer over a vertical stretching surface at lowest level of heat energy in the presence of suction is investigated. The viscosity of the fluid is assumed to vary as a linear function of temperature and thermal conductivity is assumed constant. A similarity transformation is applied to reduce the governing equations i...