The performance of the data transmission using the principle of the optical communication can be enhanced further simply by increasing both the wavelength count and bit rate per channel, so as to improve the utilization of the optical fiber bandwidth. This approach in turn requires the most suitable device structures and the technologies for both opto-electronic transducers and the associated d...

A fully-active low-noise amplifier (LNA) for ultrawideband application is presented. Passive on-chip inductor of conventional LNA design is replaced by low-noise active inductor, significantly reducing the total chip area of the proposed CMOS LNA. The core LNA circuit is a cascoded common-source amplifier loaded with an active inductor. Two buffer stages are used to provide the required input a...

In this paper, a design and fabrication of a miniaturized 2.5 GHz 8 W power amplifier using selectively anodized aluminum oxide(SAAO) substrate are presented. The process of SAAO substrate is recently proposed and patented by Wavenics Inc. which uses aluminum as wafer. The selected active device is a commercially available GaN HEMT chip of TriQuint company, which is recently released. The optim...

In this paper, reduced power consumption, low-noise CMOS amplifier using chopper technique is designed, chopper-equalized amplifier had been used as a front end of a voltage-to-frequency converter instrument which performs pretty well, and they were meeting just about every specification, but they had a problem with undesired and unpleasant little offset shifts and jumps. Trying to solve this p...

In this paper, an active compensation method using two current feedback operational amplifiers (CFOAs) to enhance the bandwidth of finite gain inverting voltage amplifier for use as stand-alone amplifier is presented. It is also shown that the inexpensive passive compensation technique can be applied to composite CFOA based amplifier to improve the phase response in addition to bandwidth enhanc...

An effective current scaling method with source degenerated resistors proposed in the design of Bulk-Driven Folded-Cascode (BDFC) amplifier. The transconductance of the amplifier significantly vary with the common mode voltage. A 0.5V efficient Band Pass Filter (BPF) using bulk driven Operational Trans conductance amplifier (OTA) is designed for detection of QRS complex in ECG signal 17Hz. A lo...

Process variation is an obstacle in designing reliable CMOS mixed signal systems with high yield. To minimize the variation in voltage gain due to variations in process, supply voltage, and temperature for common trans conductance-based amplifiers, we present a new compensation method based on statistical feedback of process information. We further apply our scheme to two well known amplifier t...

The high luminosity upgrade of the LHC (HL-LHC) at CERN will provide unprecedented instantaneous and integrated luminosities up to 7.5×1034 cm?2s?1 4500 fb?1, respectively, from 2029 onwards. To cope with extreme conditions 200 collisions per bunch crossing, increased data rates, on- off-detector electronics CMS electromagnetic calorimeter (ECAL) be replaced. A dual gain trans-impedance amplifi...