This research work highlights the effects of acoustic emission (AE) signals emitted during the milling of H13 tool steel as an important parameter in the identification of tool wear. These generated AE signals provide information on the chip formation, wear, fracture and general deformation. Furthermore, it is aimed at implementing an online monitoring system for machine tools, using a sensor f...

As more and more real wireless sensor networks (WSN) applications have been tested and deployed recently, the research community realizes that several issues need to be revisited from practical angles. In this paper, we focus on designing a general energy-efficient, load balanced, fault-tolerant, and scalable routing protocol. First, we abstract four fundamental requirements of any practical ro...

For general plane contact of elastically similar materials, including cases where there are multiple regions of contact, general properties of the partial slip solution for conditions of constant normal force and monotonically increasing shearing force have been found recently by the first author. An extension is given here to cover the unloading and cyclic loading cases. Further, it is shown t...

statement of problem: the effect of porcelain surface on the antagonist acrylic teeth has not been widely studied. objectives: this study aimed to investigate the effect of polished porcelain, glazed porcelain, and natural teeth (as the control group) on the acrylic resin teeth. materials and methods: in this experimental-laboratory study, a total of 60 specimens of glazed and polished porcelai...

The wear mechanism of plasma electrolytic nitrocarburised (PEN/C) 316L stainless steel samples was studied after a pin on disc wear test. The surface morphology of samples after application of PEN/C process was studied using scanning electron microscope technique. The sliding tracks resulting from the wear tests on the treated specimens indicated no signs of plastic deformation and adhesive wea...

polyvinyl ester green composites were synthesized with walnut shell powder (wsp) by in-situ polymerization technique. the green composites have been evaluated for mechanical properties such as tensile strength, tensile modulus and hardness. sliding wear loss, specific wear rate and coefficient of friction were investigated by using computerized pin-on–disc machine at normal applied loads of 20,...

in this research, b4c-ni cermet coating was sprayed on the surface of 4130 steel from b4c and ni feed-stockpowders using high velocity oxy-fuel (hvof) method. in order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 n.phase analysis of the coating after spraying was studied by x-ray diffracto...

in the present work, the aa2124/25vol.%mosi2 composite was produced by powder metallurgy technique. the aluminum alloy 2124 powder was produced by gas atomization method and the mosi2 intermetallic particles were produced through combustion synthesis. the aa2124 matrix powder was mechanically blended with 25vol.%mosi2 using a ball milling mixer. the blended powder mixture was encapsulated and t...

ball mills are common grinding equipment in mineral processing industries. ball wear results from three mechanisms namely impact, abrasion and corrosion. of these, the corrosion mechanism is the least investigated, due to its chemical-electrochemical nature. therefore, the aims of this research were to investigate the grinding chemistry influence (slurry ph, solid percentage, water chemistry an...