Iron released by steel corrosion was found to be a key impurity in reactions with dissolved oxygen in liquid lead-bismuth eutectic alloys. The iron-oxygen-magnetite equilibrium was characterized, allowing the quantification of phenomena that are important for long-term operation of lead-alloy based installations such as corrosion rate control and management of precipitates.

In order to lower fuel consumption and reduce emissions, aluminum is being considered as an alternative to steel in large scale production of autobodies. This study evaluates the prospects of aluminum sheets as a cost efficient alternative to steel in autobodies with the unibody design. The study focuses on the processing technologies and alloy selection for aluminum automotive sheets and looks...

Corrosion is one of the major problems in the industry especially on machinery since it weakens the structure of the machinery part and causes the mechanical failure. This will stop the production and increase the maintenance cost. In this study, the corrosion behaviour of gas nitriding on a screw press machine shaft made from AISI 4140 steel was investigated. Pitting corrosion was identified a...

The temperature of a Fe-Cr-Ni alloy (304 stainless steel) has been measured during shock compression using a high-speed radiometric technique. Experiments were performed on highquality thick films deposited on sapphire and LiF windows. The samples had no observable porosity or defects and closely meet the ideal criteria for shock temperature measurements. Data obtained with both A1203 and LiF w...

Improvement of die life in the hot forging of brass alloys is considered vital from both technical and economical points of view. In this research, pin-ondisc tests were carried out at a range of temperatures to evaluate the influence of plasma nitriding and duplex nitriding-physical vapour deposition (PVD), including TiN-TiAlN and TiN-TiAlN-CrAlN coatings, on the tribological properties of AIS...

The high-field permanent magnetic circuits of 1.2 T and 1.5 T with novel magnetic focusing and curved-surface correction are developed. The permanent magnetic circuit comprises a magnetic yoke, main magnetic steel, nonspherical curved-surface magnetic poles, plugging magnetic steel, and side magnetic steel. In this work, a novel shimming method is proposed for the effective correction of base m...

The reliability of welded structure can be evaluated through welding residual stress analysis and fatigue strength assessment. In this study, welding residual stresses of multi-pass dissimilar material welded joint between alloy 617 and 12Cr steel were analyzed numerically and experimentally. Fatigue strength was then assessed in the air. Based on results of welding residual stress analysis and...

Adding a large amount of light elements such as aluminum to steels is not a new concept recalling that several Fe-Al-Mn-C alloys were patented in 1950s for replacement of nickel or chromium in corrosion resistance steels. However, the so-called lightweight steels or low-density steels were revisited recently, which is driven by demands from the industry where steel has served as a major structu...

The drilling and riveting processes are widely used in the assembly of carrier rocket, which makes the efficiency and quality of drilling become the important factor affecting the assembly process. According to the problem existing in the drilling of thick stacked plate (thickness larger than 10mm) of carrier rocket, such as drill break, large noise and burr etc., experimental study of the infl...

The openings of Copper converter in Sarcheshmeh Copper Complex in Iranis made of a heat resisting austenitic steel (Fe-25Cr-12Ni) and many failures have been reported. Understanding the failure mechanism of the alloy helps to develop better alloys for similar complex environments. Samples of as-cast alloy and those taken from failed ones were examined. Optical Microscopy (OM), X-Ray Diffraction...