Thin alumina films have found applications in electronic circuits and cutting tools and have been recently explored as protective coatings against high temperature oxidation, but these studies have been relatively rare. In this study, amorphous alumina films 3.5 pm thick were produced by reactive sputtering on Co-30Cr-6Al-0.5Y coatings, using a pure aluminum target in Ar + 0 2 atmosphere. Isoth...

An efficient and green protocol for the synthesis of αaminonitriles derivatives by one-pot reaction of different aldehydes with amines and trimethylsilyl cyanides has been developed using natural alumina, alumina sulfuric acid (ASA), nano-γ-alumina, nanoalumina sulfuric acid (nano-ASA) under microwave irradiation and solvent-free conditions. The advantages of methods are short reaction times, h...

This paper presents a hierarchically designed polymer nanocomposite approach in which nanofillers at ultralow volume loading generate large dielectric enhancement blends of high temperature polymers with tailored nanostructures. We blend poly(1,4-phenylenen ether sulfone) (PES) polymers, such as polyetherimide (PEI), that possess more coiled chain conformations to tailor nano-morphologies. Maki...

MWCNTs produced by using Chemical Vapor Deposition (CVD) technique were functionalized with nitric and sulfuric acid to ensure a good dispersion in an aqueous solution. The FTIR analysis further confirmed the presence of carboxyl and hydroxyl groups on the surface of MWCNTs after acid treatment. The two types of MWCNTs composites were prepared using pristine and ...

Interpenetrating Al O /Al composites were created by liquid metal infiltration of alumina structures with three-dimensional periodicity produced by a robotic deposition method. Volume-averaged lattice strains in the alumina phase were measured by synchrotron X-ray diffraction at various uniaxial compression stresses up to 200 MPa. Load transfer was observed to occur from the aluminum to the alu...

BACKGROUND Numerous studies have reported that microgrooves on metal and polymer materials can affect cell adhesion, proliferation, differentiation and guidance. However, our knowledge of the cell activity associated with microgrooves on ceramics, such as alumina, zirconia, hydroxyapatite and etc, is very incomplete, owing to difficulties in the engraving of microgrooves on the hard surface of ...

Lanthanide (Ln3+) doping in alumina has shown great promise for stabilizing and promoting desirable phase formation to achieve optimized physical and chemical properties. However, doping alumina with Ln elements is generally accompanied by formation of new phases (i.e. LnAlO3, Ln2O3), and therefore inclusion of Ln-doping mechanisms for phase stabilization of the alumina lattice is indispensable...

This paper considers the degradation of alumina and zirconia toughened alumina vs. alumina for hip implants. The materials are as assumed to be load bearing surfaces subjected to shocks in wet conditions. The load is a peak of force; 9 kN was applied over 15 ms at 2 Hz for 800,000 cycles. The volumetric wear and roughness are lower for ZTA than for alumina. The long ZTA ageing did not seem to h...

A multi-analyte, multi-matrix method was developed for the routine determination of steroids in animal tissues (skin, meat and fat). After addition of internal standards and sample pre-treatment, the analytes of interest were extracted from the matrix with unmodified supercritical CO2 and trapped directly on an alumina sorbent placed in the extraction vessel (in-line trapping under supercritica...

Anodic porous alumina has been widely investigated and used as a nanostructure template in various nanoapplications. The porous structure consists of numerous hexagonal cells perpendicular to the aluminum substrate and each cell has several tens or hundreds of nanoscale pores at its center. Because the nanomorphology of anodic porous alumina is limited by the electrolyte during anodizing, the d...