1.0 Introduction ..........................................................................................................................................................2 2.0 Relevant Topics in Sound and Acoustics ............................................................................................................... 2.1 Sound...............................................................

This study made comparisons of the expected noise and durability performance of asphalt surface mixes based on laboratory testing only, and recommended a set of surface mixes for field test sections with improved surface performance properties. The study included a series of experiments to investigate the effects of several important mix variables identified in studies of field test sections, i...

The Alabama Department of Transportation and the National Center for Asphalt Technology (NCAT) are planning to construct and operate an oval test track (accelerated pavement loading facility) to evaluate the performance of various hot mix asphalt (HMA) test pavements. Auburn University has purchased 310 acres of land approximately 15 minutes from the university for the test track. Construction ...

Pavement maintenance and rehabilitation have been neglected in Nigeria for a very long time and has resulted to maintenance backlog. Design agencies in Nigeria still use California Bearing Ratio (CBR), even though the method is outdated. An introduction of Dynamic Cone Penetration Test (DCPT) was pertinent, even though the method is relatively old in some developed countries, it has not gain mu...

In the Mechanistic–Empirical Pavement Design Guide (MEPDG), dynamic modulus of asphalt mixes is used as one of the input parameters in pavement analysis and design. For in-service pavements, MEPDG method uses a combination of some field and laboratory tests for structural evaluation of asphalt layers in rehabilitation projects. In this study, ten new and rehabilitated in-service asphalt pavemen...

The objective of this study is to review existing literature in the area of nano-modification of asphalt and proceed to apply nano-materials to asphalt to improve the performance. This study integrates literature review, preparation, and characterization of nano-modified asphalt materials. In the experimental testing montmorillonite, nanoclay at 2% and 4% by weight of asphalt was blended in asp...

Clay ball is a pavement surface defect which refers to a clump in which clay or dirt is 8 mixed with hot asphalt mixture. Clay ball is typically caused by a combination of aggregate 9 contamination of clay or soil, high aggregate moisture, and low production temperature at the 10 asphalt plant. It usually appears a few weeks or months after paving under traffic load, after being 11 liquefied an...

The high contribution of CO 2 emissions associated with pavements has driven research to assess the life cycle of concrete versus asphalt structures and to develop a strategy to reduce the carbon footprint. The life cycle of pavement has been studied with respect to CO 2 emissions in the use phase of concrete as well as after the concrete is demolished. However, only a few have considered the e...

Fatigue life of asphalt mixes in laboratory tests is commonly determined by applying a sinusoidal or haversine waveform with specific frequency. The pavement structure and loading conditions affect the shape and the frequency of tensile response pulses at the bottom of asphalt layer. This paper introduces two methods for predicting the loading frequency in laboratory asphalt fatigue tests for b...

Components of road surface degradation are common constituents of urban runoff. Studies conducted in Europe have indicated that as much as 0.05-0. 10 inch of pavement surface is worn away from the roadway each year. The largest component of street pavement is the aggregate material itself, with additional smaller quantities originating from the asphalt binder, fillers and substances applied to ...