A study of high-pressure bubble growth within liquid droplets heated to their limits of superheat is reported. Droplets of an organic liquid (n-octane) were heated in an immiscible nonvolatile field liquid (glycerine) until they began to boil. High-speed cine photography was used for recording the qualitative aspects of boiling intensity and for obtaining some basic bubble growth data which hav...

n this study, two silicon wafer substrates were coated with vertially aligned multiwalled carbon nanotubes (MWCNT) “forests” nd were used for pool boiling studies. The MWCNT forests (9 nd 25 m in height) were synthesized on the silicon wafer subtrates using chemical vapor deposition (CVD) process. The subtrates were clamped on a cylindrical copper block with embeded cartridge heaters. The heat ...

The light chains (LCa and LCb) of bovine brain clathrin are resistant to heat denaturation by boiling, a property shared by tropomyosin (Bailey, K., 1948, Biochem. J., 43:271-281). Light chains were partially purified by boiling and centrifugation of a Tris-extract of crude membranes prepared from bovine brains (Keen, J. H., M. C. Willingham, and I. H. Pastan, 1979, Cell., 16:303-312). Contamin...

The power deposited by a 20 MW beam of 2 GeV protons has been calculated for a Liquid Mercury Target. Beam size and shape critically influence the deposited power density. A principle limitation of the liquid metal is in the temperature range that can be considered should boiling be avoided while operating at a relatively high repetition rate (> 50 Hz). This has a limiting effect on the power t...

A review concerning pervaporation and vapor permeation membrane separation techniques used to separate liquid mixtures, is presented. Examples of polymers for membrane preparation as well as performance parameters of pervaporation and vapor permeation membranes are described. The second part of the paper presents applications of pervaporation and vapor permeation in environmental protection. At...

Some thermodynamic quantities for the Stockmayer potential (12, 6, 3) with a hard core are analytically evaluated at an isobaric process. The parameters of polar gases for 16 substances are obtained. Also some thermodynamic quantities for H2O are calculated numerically and drawn graphically. The inflexion point of the length L corresponds physically to a boiling point. L indicates the liquid ph...

A new mass-conservative phase change model has been developed for the nucleate boiling simulation. The conservative CIP scheme is used for surface tracking in order to satisfy the mass conservation exactly. As the phase change model, a sharp-interface model is developed, in which the phase change rate can be computed from the heat flux to the interface in a straightforward manner. The developed...

We study heat transfer from a heated nanoparticle into surrounding fluid using molecular dynamics simulations. We show that the fluid next to the nanoparticle can be heated well above its boiling point without a phase change. Under increasing nanoparticle temperature, the heat flux saturates, which is in sharp contrast with the case of flat interfaces, where a critical heat flux is observed fol...

The interfacial area transport equation for a subcooled boiling flow is developed with a mechanistic model for the wall boiling source term. It includes the bubble lift-off diameter model and the lift-off frequency reduction factor model. Those models take into account a bubble’s sliding on the heated wall after a departure from the nucleate site and the coalescences of sliding bubbles. To impl...