Cohesive-frictional soils are widely used in the construction of embankment structures and due to the method of construction, i.e. applying compactive efforts in the vertical direction in these cases, the occurrence of anisotropy in the soil strength and permeability seems to be inevitable. In this study, attempts have been made to evaluate the shear strength of c-f soils through modifying a l...

Nine restrained T-beams were tested in a study of the negative moment region shear strength of lightly reinforced concrete T-beams. Variables included the longitudinal reinforcement ratio p, (0.47 percent and 0. 70 percent) and the nominal stirrup strength (0 to 84 psi [0 to 0.60 MPa]). The test results are compared with the shear provisions of "Building Code Requirements for Reinforced Concret...

To evaluate the effect of a dentin adhesive on sclerotic dentin, contraction gap width and shear bond strength were measured. Dentin cavity wall was pretreated with an experimental dentin bonding system with and without a dentin primer, or with a commercial dentin bonding system. In the experimental dentin bonding groups, contraction gap width of sclerotic dentin was significantly smaller than ...

[1] A high resolution active source dataset recorded across the Southern Alps of New Zealand displays unusually strong S-wave phases, which show minimal shear wave splitting. A suite of methods was used to analyse the data to minimize the uncertainty in the anisotropy measurements. We use the Silver and Chan [1991] method, cross correlation of stacked data, and deconvolution in combination with...

One of the most important and the most controversial engineering properties of soil is its shear strength or ability to resist sliding along internal surfaces within a mass. The stability of a cut, the slope of an earth dam, the foundations of structures, the natural slopes of hillsides and other structures built on soil depend upon the shearing resistance offered by the soil along the probable...

In this paper, dissimilar resistance spot welding of AISI 1075 eutectoid steel to AISI 201 stainless steel is investigated experimentally. For this purpose, the experiments are designed using response surface methodology and based on four-factor, five-level central composite design. The effects of process parameters such as welding current, welding time, cooling time and electrode force are inv...

BACKGROUND Silorane-based composites and their specific self-etch adhesive were introduced to conquest the polymerization shrinkage of methacrylate-based composites. It has been shown that additional etching of enamel and dentin can improve the bond strength of self-etch methacrylate-based adhesives but this claim is not apparent about silorane-based adhesives. Our objective was to compare the ...

1.1 Background The California Bearing ratio (CBR) test has been widely used in pavement design since mid 1940’s. It is a relative measure of subgrade soil or base/subbase aggregate strength. The Virginia Department of Transportation (VDOT) has been using its own Virginia Test Method-8 (VTM-8) to perform CBR testing. On the other hand, private industry and other DOT’s are using AASHTO (American ...

the spot welding is widely used for joining thin sheets in different industries; such as automotive industry. this method of welding is very easy to automate and maintain. in this study, the effect of nugget diameter on the tensile-shear strength of the spot welding joints was investigated. the specimens were manufactured from aisi 1008 hr sheets with 1.0 mm thickness. the eight different elect...