Compared to mechanical compressors, ejector-based refrigeration systems can make direct use of many forms thermal energy, including waste heat, solar thermal, or biogases. It is known that SE have a lower efficiency compared compressors because their performance at high compression ratios. In the present work, binary fluid ejector heat pumps with are presented based on proper selection fluids a...

The effective waste heat recovery is one of the present-day challenges in the industry and power engineering. The energy systems dedicated for waste heat conversion into electricity are usually characterized by low efficiency and are complicated in the design. The possibility of waste heat recovery via thermoelectric materials may be an interesting alternative to the currently used technologies...

In this study, a reputable Kalina cycle system, KCS 11, is simulated and analysed. Within this efficient cycle, there are three heat exchangers: the first heat exchanger is designated for heat absorption from the heat source, the second heat exchanger is designed for heat release to the cold source, and the third heat exchanger is designed for energy recovery. In order to achieve precise si...

This paper presents a significant method and a basic idea of waste heat recovery from high temperature slags based on Time Temperature Transformation (TTT) curves. Three samples with a fixed CaO/SiO2 ratio of 1.05 and different levels of Al2O3 were designed and isothermal experiments were performed using a Single Hot Thermocouple Technique (SHTT). The TTT curves established through SHTT experim...

nowadays, energy plays an important role in the economic and community development of country. consequently, performance analysis of energy systems is one of the effective methods being used to prevent waste of energy resources. among the different power generation technologies, steam power plants make a significant contribution to power generation in iran, with a share of 47 % of electricity g...

Continuous capacity modulation, for example by varying compressor speed, is only one alternative to conventional cycling of vapor compression systems. Cycling the compressor at higher frequencies (~0.01–0.1 Hz) than conventional systems (~0.001 Hz) offers a potentially simpler and less costly alternative. Experiments were conducted to quantify effects of steady vs. pulsed flow on the performanc...

An experimental study has been conducted to evaluate the performance of a compact round-tube louver-fin condenser, each with frontal areas of 0.25 m in both dry and wet conditions. Deluge water cooling is achieved by incorporating a perforated bottom plate-type water distributor on top of the round tube heat exchanger. Water is used as a refrigerant, and enters the heat exchanger tubes at 35°C ...

This paper presents the numerical analysis of a Miniature-Scale Refrigeration System (MSRS) for electronics cooling. The system consists of a simulated electronic chip attached to a microchannel cold plate evaporator, a compressor, a microchannel condenser, and an expansion device. The system uses R-134a as the refrigerant. A copper block heater is designed to simulate the heat generation of an...

An updraft tower cooling system is assessed for elimination of water use associated with power plant heat rejection. Heat rejected from the power plant condenser is used to warm the air at the base of an updraft tower; buoyancy-driven air flows through a recuperative turbine inside the tower. The secondary loop, which couples the power plant condenser to a heat exchanger at the tower base, can ...

The research aims to utilize polyethylene (PET), polypropylene (PP) and polystyrene (PS) plastic waste into liquid fuel by the pyrolysis process, currently, especially in Surabaya, a lot of waste, 13% - 14% is plastic. results sample from this study are distinguish temperature steam entering condenser also water condenser. And what will later be tested that oil close type gasoline or diesel. fo...