Multicell converter are a very interesting alternative for medium and high power drives. This paper presents a new configuration of double flying capacitor (DFCM) converter. The main advantages of the proposed converter in comparison with FCM and stacked multicell converter are doubling the rms and the number of output voltage levels, improving the output voltage frequency spectrum, and cancell...

This paper proposes a new passive snubber for enhancing the power conversion efficiency on a single phase ac-dc power factor correction (PFC) converter based on boost topology for battery charging systems. Soft switching can be achieved in the proposed converter with the proposed auxillary passive snubber circuit which is added to the conventional boost PFC converter. The converter switch is pr...

This paper presents a comparative study on the Predictive Direct Torque Control method and the Indirect Space Vector Modulation Direct Torque Control method for a Doubly-Fed Induction Machine (DFIM) which its rotor is fed by an Indirect Matrix Converter (IMC). In Conventional DTC technique, good transient and steady-state performances are achieved but it presents a non constant switching fr...

2.4: (a) Load Resonant Inverter Schematic, (b) Control Circuit. 24. Fig. Voltage and current source inverter was invented before resonant inverter, but resonant. 2.1 Resonant Switching theory and converter classification. 2.2.3 Series Parallel Resonant Converter (SPRC). A.1.10 Verify resonant-circuit converter. The resonant inverters used to supply the inductor-pot system can be classified Thus...

Energy storage system has been widely applied in power distribution sectors as well as in renewable energy sources to ensure uninterruptible power supply. This paper presents a model predictive algorithm to control a bidirectional AC-DC converter, which is used in an energy storage system for power transferring between the three-phase AC voltage supply and energy storage devices. This model pre...

A novel soft-switching two-switch flyback converter is proposed in this paper. This converter is composed of two active power switches, a flyback transformer, a blocking diode, and two passive regenerative clamping circuits. The proposed converter has the advantages of a low cost circuit configuration, a simple control scheme, a high efficiency, and a wide operating range. The circuit topology,...

This paper provides design and implementation of a DC-DC boost converter control system by using gain scheduling PI-controller to achieve stable regulated output voltage with improved dynamic performance. The proposed controller parameters are obtained from system output response based on step input signal. A test step input is applied to the system and the three parameters of the plant are obt...

This paper presents a method for designing the control loop for dc-to-dc converters when uncertainties exist in the ac characteristics of the converter’s load. In the proposed method, a converter is initially considered as a stand-alone module feeding a current sink load and the control loop of the converter is then designed in a way that maximizes the robustness of the converter’s closed-loop ...

A new "model-free" control methodology is applied to a boost power converter. The properties of the boost converter allow to evaluate the performances of the model-free strategy in the case of switching nonlinear transfer functions, regarding load variations. Our approach, which utilizes "intelligent" PI controllers, does not require any converter model identification while ensuring the stabili...

This work describes the main consideration in the design of power converter for a SRM drive with the particular attention to the choice of converter topology, and to study and develop the static and dynamic characteristics of the prototype model of SRM using FEA software (MagNet 6. 22). To simulate the power converter switching circuit for prototype model of SRM using MATLAB/Simulink 7. 8. 0. I...