The boost topology is the most popular topology used in power factor correction circuits. The efficiency and performance of the boost converter depends on the switching frequency affecting the switching losses. At high frequency operations the switching losses of the converter is considerable and decreases the efficiency of the converter. To remove this problem the converter is designed to oper...

Portable electronic devices not only require switching DC-DC converters to be compact and integrated but also compliant to wide off-chip LC filter variations, which are subject to manufacturing tolerances, temporal and thermal parameter drifts, and more often than not, application-driven constraints. While optimal LC compliance has been demonstrated in ΣΔ buck converters, little has been done i...

This paper deals with the simulation of closed loop and open loop controlled Interleaved Boost Converter (ILBC). It is seen that, for higher power applications, more modules can be paralleled to increase the power rating and the dynamic performance. One of the challenge in designing a boost converter for high power application is how to handle the high current at the input side. In this paper a...

This study presents a high-efficiency low-noise pulse-width modulation (PWM) DC–DC buck converter based on multi-partition switching for mobile system-on-a-chip applications. A multi-partition switching technique is employed for the control of large current driving switches to minimise the switching noise. In addition, a PWM control with a switching frequency of 2 MHz is applied for the driving...

Switched Boost Inverter (SBI) is a single stage DC to AC power converter and it is derived from the Z source inverter employs an LC impedance network in between the main inverter bridge and the power source. This SBI converter can possible to supply both DC and AC loads simultaneously from a single dc input source. Here, reducing the inverter switching stress. Also, this converter provides to s...

A hybrid approach of the DC-DC conversion is presented for battery-operated portable electronics systems such as wearable health monitoring devices. A switched-capacitor (SC) DC-DC converter is steered by hysteretic control to provide buck-boost conversion with a flexible conversion ratio, and its output is regulated by a low-drop-out (LDO) regulator delivering a low-ripple DC output. The SC DC...

This paper focuses on modeling, analysis and simulation of a 42V/14V dc/dc converter based architecture. This architecture is considered to be technically a viable solution for automotive dual-voltage power system for passenger car in the near further. An interleaved dc/dc converter system is chosen for the automotive converter topology due to its advantages regarding filter reduction, dynamic ...

Nonlinear phenomena in closed-loop pulsewidth modulation (PWM) dc/dc converters have been reported recently. In this paper, we investigate experimentally these phenomena in a voltage-mode controlled buck converter operating in continuous-conduction mode. In particular, the complex behavior of a voltage feedback buck converter is studied for wide variation of input voltage and different load res...