This paper presents holistic design of a novel 4-way differential power-combining transformer for use in mm-wave power-amplifier (PA). The combiner with an inner radius of 25 um exhibits a record low insertion loss of 1.25 dB at 83.5 GHz. It is designed to simultaneously act as a balanced-to-unbalanced converter, removing the need for additional BALUNs typically required in differential circuit...

The Drosophila transformer-2 gene uses alternative promoters and splicing patterns to generate four different mRNAs that together encode three putative RNA-binding polypeptides. The transformer-2 products expressed in somatic tissues function to regulate the RNA splicing of the sex determination gene doublesex, whereas products expressed in the male germ line play an unknown, but essential, rol...

Under different types of internal and external faults transformers, electrical quantities such as voltage, differential current transformer oil flow rate change accordingly. In this paper, the variation law is studied, other under abnormal conditions inside outside area verified by simulation. The characteristics are different, judged. At same time, ANSYS Maxwell 3D, Fluent software used to mod...

The behavior of three phase five leg transformer under voltage sag is studied in this paper. This paper proposes a simple, practical model of a three phase-five leg, saturated transformer with accurate performance. Transformer saturation is produced when the voltage sag is recovered and it causes inrush current in transformer. Effects of voltage sag depth, duration and initial point on wave hav...

With the evolution of Process Bus (IEC 61850-9-2), there is a need to assess the performance of protection schemes using process bus against those where traditional copper wires are implemented. Differential protection is the fundamental and most commonly used protection for transformers, motors and generators. In this paper a power system is modelled in SimPowerSystems and is executed in real-...

Transformer inrush currents are highmagnitude, harmonic-rich currents generated when transformer cores are driven into saturation during energization. These currents have undesirable effects, including potential damage or loss-of-life to the transformer, protective relay misoperation, and reduced power quality on the system. Controlled transformer switching can potentially eliminate these trans...

The most common cause of power transformer failures is mechanical defect brought about by excessive vibration, which is formed by the combination of multiples of a frequency of 120 Hz. In this paper, the types of mechanical exciting forces applied to the power transformer were classified, and the mechanical damage mechanism of the power transformer was identified using the vibration transfer ro...

The power transformer is one of the most important equipment in a power system. Optimal design of transformer involves determination of design parameters of a power transformer when a chosen objective is optimized, simultaneously satisfying a set of constraints. In this paper Simulated Annealing (SA) is used for optimization of Power Transformer Design (OPTD).The total mass of core and copper i...