a computational optimization was performed for a direct-injection diesel engine using three-dimensional modeling. fully transient cfd analyses of different valve profile strategies for the intake and compression strokes were performed to evaluate the effects on both engine performance and in-cylinder flow-field evolution. the turbulence model was used along with the second order linear upwind s...

Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and n...

Turbocharged CNG engines produce high NOx emission due to the fuel type and high combustion temperature. In this research, the effects of lean-burn and waste gate opening pressure threshold on NOx emission are studied theoretically and experimentally at WOT condition as well as 13-mode ECE-R49 test cycle. A code is developed in MATLAB environment for predicting engine NOx and the results are va...

A pyroscrubber is the device used in petroleum coke Calcining industry to oxidize the carbonaceous contents, including hydrocarbon volatiles of the exhaust gas from the calcination kiln, so as to recover energy to produce electricity and leave no more than small traces of unburned volatiles, solid carbon, ashes, or emissions (e.g. CO, NOx and SOx) in the flue gas finally discharged. Motivated b...

Combustion, performance and emission were studied for DI diesel engine fuelled with DMM/diesel fuel blends for DMM content from 0 to 50%. Results showed that, for diesel engine with fuel supply system and combustion system unchanged, with increased DMM percentage, thermal efficiency slightly increases; smoke and CO emissions decrease, NOx remains almost unchanged while HC increases a little; fo...

Control of Particulate matter (PM) emission is a key pollution issue affecting the environment and human health, especially sizes that range below 10 μm. The objective of this work is to develop a dust flow separator type electrostatic precipitator (DFS-ESP) for the effective control of fine particulate matter emission from natural gas combustion. An experiment was conducted for natural gas com...

In this work, number concentration and size distribution at the exhaust of a Port Fuel Injection (PFI) Spark Ignition (SI) engine downstream a three-way catalyst and a Direct Injection Common Rail Diesel engine have been measured with two particle size instruments. The gas exhaust is first diluted, a nano DMA is used to obtain the particles size distribution function in the 3-60 nm range, in pa...

Emission factor is a relative measure and can be used to estimate emissions from multiple sources of air pollution. For this reason, data from literature on particulate matter emission factors from different types of biomass were evaluated in this paper. Initially, the main sources of particles were described, as well as relevant concepts associated with particle measurements. In addition, arti...