The driver is for a direct injection engine with 2 to 4 cylinders. There is one injector for every cylinder. To guarantee the pressure to be constant during every single injection stroke not more than 4 concurrent injections may be performed. As a consequence, for engines with at most 4 cylinders, every cylinder may be considered independent. Therefore, we may focus on the design of the driver ...

Loading conditions and complex geometry have led the cylinder heads to become the most challenging parts of diesel engines. One of the most important durability problems in diesel engines is due to the cracks valves bridge area. The purpose of this study is a thermo-mechanical analysis of cylinder heads of diesel engines using a two-layer viscoelasticity model. The results of the thermo-mechani...

A heat transfer model has been developed that uses quasi-steady heat flux relations to calculate the heat transfer from combustion gases through the cylinder wall to the coolant in an internal combustion engine. The treatment of convective heat transfer accounts for the physical problems of rotating and impinging axial flow inside the engine cylinder. The radiative heat transfer includes gas ra...

Loading conditions and complex geometry have led the cylinder heads to become the most challenging parts of diesel engines. One of the most important durability problems in diesel engines is due to the cracks valves bridge area. The purpose of this study is a thermo-mechanical analysis of cylinder heads of diesel engines using a two-layer viscoplasticity model. In this article, mechanical p...

The present study conducted experimental investigation on combustion and emission characteristics of compression ignition engine using diesel as pilot fuel and methane, hydrogen and methane/hydrogen mixture as gaseous fuels at 1800 rev min. The effect of gaseous fuel on peak cylinder pressure and heat release is modest at low to medium loads. At high load, the high combustion temperature and hi...

Engine management systems (EMS) need feedback on combustion performance to optimally control internal combustion engines. Ion sensing is one of the cheapest and most simple methods for monitoring the combustion event in a spark ignited engine, but still the physical processes behind the formation of the ionization current are not fully understood. The goal here is to investigate models for ioni...

Control of diesel fuel injection is very important and has influence not only at engine operating conditions but also at emission of toxic gases as NOx, HC, and Particulate Matter (PM) are effect of combustion process. Directly observing of combustion process is very difficult, but implementation to injection control algorithm procedures based on additional sensors as knock sensor, cylinder pre...

Recent research in laser-induced ignition (LI) of air-fuel mixtures in internal combustion (IC) engines has shown there to be many potential advantages over conventional electrical spark ignition (SI). Spark plugs offer only limited possibilities for optimising engine efficiency, due to their fixed position within a cylinder and the protrusion of electrodes which disturb the cylinder geometry a...

Three different approaches for modeling diesel engine combustion are compared against cylinder pressure, NOx emissions, and simultaneous optical diagnostic images from a heavy-duty, DI diesel engine. A characteristic time combustion (KIVA-CTC) model, a representative interactive flamelet (KIVA-RIF) model, and direct integration using detailed chemistry (KIVA-CHEMKIN) were integrated into the sa...

This paper presents the coating thickness effect on the stress distribution of a coated cylinder head. A typical thermal barrier coating was applied on a diesel engine cylinder head. Thus, the residual stress which occurred during the plasma thermal spraying was also considered. The coating system consisted of two layers a metallic bond coat and a ceramic top coat. The bond coat thickness is co...