Missing anterior teeth is of serious concern in the social life of a patient in most of societies. While conventional fixed partial dentures and implant-supported restorations may often be the treatment of choice, fiber-reinforced composite (FRC) resins offer a conservative, fast, and cost-effective alternative for single and multiple teeth replacement. This paper presents two cases where FRC t...

The purpose of this study was to evaluate the design of resin-bonded fixed partial dentures (RBFPDs) with zirconia frameworks. The abutment teeth were the upper central incisor and the canine. Three types of frameworks were fabricated as follows: 0.5-mm- and 0.8-mm-thick zirconia frameworks with grooves and holes (0.5ZrG, 0.8ZrG) and 0.5-mm-thick zirconia frameworks without grooves and holes (0...

Various studies have proved the success of the osseointegration concept, if proper and strict protocols are followed for the success. In clinical practice, certain situations arise that makes the clinician to modify his treatment modality to favor the final outcome of the treatment. This paper presents a clinical case report of re-osseointegration of the loosened bead implant occurred during th...

The aim of this study was to investigate the marginal fit of posterior fixed partial dentures (FPDs) made with 2 computer-aided design/computer-assisted manufacture systems--Procera Bridge Zirconia (Nobel Biocare) and Lava AllCeramic System (3M ESPE)--and to analyze the differences between abutments and between buccal and lingual surfaces. Twenty standardized specimens were prepared to receive ...

One of the most important steps is accurate impression making for fabrication of fixed partial denture. The two different putty-wash techniques that are commonly used are: (1) Putty-wash one-step technique, (2) putty-wash two-step technique. A uniform wash space is needed for an accurate impression. Nissan et al recommended the use of two-step technique for accurate impression making as there i...

PURPOSE The aim of this study was to measure the changes on the marginal and internal adaptation of zirconia based anterior fixed partial dentures after the porcelain firing process. MATERIALS AND METHODS A total of 34 anterior fixed partial dentures using LAVA CAD/CAM system (3M ESPE, Germany) were applied. Two silicone replicas were obtained: one is obtained before porcelain firing process ...

The most challenging job for a prosthodontist is to rehabilitate the partial edentulous patient especially distal extension cases where fabrication of fixed prosthesis is quite impossible without using implants. Several conventional and contemporary treatment options were available for treating long span edentulous situations. For such cases ,attachment retained cast partial dentures would be t...

The major disadvantage of cement-retained implant-supported fixed partial dentures (FPDs) is difficulty in retrievability. The retentive strengths of the provisional luting agents usually employed in these cases are therefore an important consideration. This study evaluated the cement failure loads of 4 provisional luting agents used for the cementation of FPDs supported by 2 implants or 4 impl...

This article describes a method of making an accurate interocclusal record when the most distal tooth is an abutment of a fixed partial denture. The method uses conical stops, prepared in the enamel of the abutment or made of composite or a metal core covered with composite, to maintain the vertical dimension of occlusion and to act as a third point of reference for a stable occlusal relationsh...