This involves having production units distribute to the consuming units through a single vertical and central distribution network. Each fl oor is served by an indirect connected substation (Figure 3). Enhancing comfort1 and reducing energy demand2 is possible when fl oorto-fl oor (rather than building-to-building) consumption is moderate (cooling) or low (heating) temperature radiant-based sur...

When operated, the cabin climate control system is the largest auxiliary load on a vehicle. This load has significant impact on fuel economy for conventional and hybrid vehicles, and it drastically reduces the driving range of all-electric vehicles (EVs). Heating is even more detrimental to EV range than cooling because no engine waste heat is available. Reducing the thermal loads on the vehicl...

We examine recent developments in the cluster cooling flow scenario following recent observations by Chandra and XMM-Newton. We show that the distribution of gas emissivity verses temperature determined by XMM-Newton gratings observations demonstrates that the central gas, i.e., where the cooling time is less than the age of the cluster, in cooling flow clusters cannot be in simple steady-state...

To investigate magnetostructural relationships in colloidal magnetite (Fe3O4) nanoparticles (NPs) at high temperature (300-900 K), we measured the temperature dependence of magnetization (M) of oleate-capped magnetite NPs ca. 20 nm in size. Magnetometry revealed an unusual irreversible high-temperature dependence of M for these NPs, with dip and loop features observed during heating-cooling cyc...

The isolation of cananga oil by a new process, Instantaneous Controlled Pressure Drop (DIC), was investigated. This process consists in heating the dry cananga (Cananga odorata Hook. fil. et Thomson, forma macrophylla) flowers for a short time period by steam, followed by an abrupt pressure drop into a vacuum (about 5 kPa). This pressure drop provokes auto-vaporization of the volatile compounds...

Abstract In recent years, elastocaloric cooling technology has been considered as one of the most promising alternatives to vapor compression technology. Given that is only in early stages development, a uniform method for evaluating effect not yet established, and thermodynamics different cycles have studied detail. Therefore, main goal this work investigate these two important areas. Here, mu...

Air source heat pumps are widely used for residential heating because of their relatively low installation costs. Major disadvantages are that the heat output and COP decrease and the discharge temperature of the compressor increases as the outdoor temperature decreases. All of these factors usually lead to the need of combined heat pump and backup heating systems, which increases the cost and ...

A multigeneration system based on solar thermal energy associated with hot and cold thermal storage is designed and analyzed energetically and exergetically. The system produces electricity, a heating effect, a cooling effect, hydrogen, and dry sawdust biomass as outputs by means of organic Rankine cycles, a heat pump, two absorption chillers, an electrolyser, and a belt dryer. The intermittent...

Data of optical performance, thermal stability and ageing are given for solar selective coatings (SSC) based on a novel MoSi2-Si3N4 absorbing composite. SSC have been prepared as multilayer stacks formed by silver as metallic infrared reflector, a double layer composite and an antireflective layer (doi: 10.1016/j.solmat.2016.04.001 [1]). Spectroscopic reflectance data corresponding to the optic...