Abstract—A bidirectional high gain four-element printed dipole array for WLAN (2.4/5.8GHz) applications is analyzed and successfully implemented in this paper. Each element used is a double-side printed dipole fed with a balance twin-lead transmission line. A wide-band balun is implemented for the dipole array. Both simulated and measured data are pretty matched. According to the measured resul...

Many types of GNSS antennas have been developed in recent years to make them suitable for different applications. Since their designs and performance requirements vary depending on their application, they have been grouped into six different categories in this book: 1. The design and performance of each type of antenna will be described here and throughout the rest of the book. This chapter dis...

Underactuated mechanical systems are systems with less actuators than degrees of freedom. Therefore, it is complicated to measure all states, i.e. angular positions or angular velocities, of the mechanical system. Alternative solution consists in an observer design such that unmeasurable states are estimated. For this purpose, a high gain observer for an Acrobot was introduced. By virtue of an ...

Coupling of a far-field optical mode to electronic states of a quantum absorber or emitter is a crucial process in many applications, including infrared sensors, single molecule spectroscopy, and quantum metrology. In particular, achieving high quantum efficiency for a system with a deep subwavelength quantum absorber/emitter has remained desirable. In this Letter, a hybrid optical antenna base...

We investigate the operation of holmium-doped fibre amplifiers (HDFAs) in the 2.1 µm spectral region. For the first time we demonstrate a diode-pumped HDFA. This amplifier provides a peak gain of 25 dB at 2040 nm with a 15 dB gain window spanning the wavelength range 2030 - 2100 nm with an external noise figure (NF) of 4-6 dB. We also compare the operation of HDFAs when pumped at 1950 nm and 20...

Emerging large-area technologies based on organic transistors are enabling the fabrication of low-cost flexible circuits, smart sensors and biomedical devices. High-gain transistors are essential for the development of large-scale circuit integration, high-sensitivity sensors and signal amplification in sensing systems. Unfortunately, organic field-effect transistors show limited gain, usually ...

This paper deals with the observability analysis and the observer synthesis of a class of nonlinear systems. The observer that we consider has a constant gain and concerns a class of uniformly observable systems. A sufficient condition permitting to design such a constant gain observer is given. The calculation of this gain is based on LMI technics.Copyright c © 2008 IFAC

A fast settling multipath CMOS OTA for high speed switched capacitor applications is presented here. With the basic topology similar to folded-cascode, bandwidth and DC gain of the OTA are enhanced by adding extra paths for signal from input to output. Designed circuit is simulated with HSPICE using level 49 parameters (BSIM 3v3) in 0.35μm standard CMOS technology. DC gain achieved is 56.7dB an...

the aim of this study was to design the base breeding plan in sistani cattle by using of stochastic simulation. for this purpose, three population size (500, 1000, 2000 heads), three levels of herd number (5, 10, 20), two levels of selection intensity (high and low) and two levels of mating method (random and minimum co-ancestry) were combined together and in total 36 scenarios were compared fo...

The OPA643 provides a level of speed and dynamic range previously unattainable in a monolithic op amp. Using a de-compensated voltage feedback architecture with two internal gain stages, the OPA643 achieves exceptionally low harmonic distortion over a wide frequency range. The "classic" differential input provides all the familiar benefits of precision op amps, such as bias current cancellation...