The main purpose of this article is to study fabrication methods and applications of aligned carbon nanotube (CNT) membranes as a hydraulic microstructure in treatment processes. This paper emphasizes the use of CNTs as membrane in separation processes like water and wastewater treatment because of their exclusive advantages. Their most important characteristics are high mechanical strength aga...

OBJECTIVES Bulk-fill composites have emerged, arguably, as a new "class" of resin-based composites, which are claimed to enable restoration in thick layers, up to 4mm. The objective of this work was to compare, under optimal curing conditions, the physico-mechanical properties of most currently available bulk-fill composites to those of two conventional composite materials chosen as references,...

Hydrothermally synthesized acicular nano-apatite (Nap) was used as filler to make composites with a polyethylene glycol/poly(butylene terephthalate) (PEG/PBT) block copolymer (Polyactive 70:30). The Nap had a particle diameter of 9-25 nm and a length of 80-200 nm. The mechanical properties and the physiochemical characteristics of the composites, such as Young's modulus, swelling degree in wate...

BACKGROUND Respiratory muscle function and lung and chest wall mechanics are reliably assessed by esophageal and gastric balloon catheters. The aim of this in vitro bench study was to assess the mechanical properties of commercially available balloon catheters using an experimental model with 3 defined compliances (27, 54, 90 mL/cm H2O). METHODS Six catheters were investigated in 4 conditions...

The paper presents some researches concerning the mechanical properties of composite materials used for prosthetic dental elements. After a short introduction concerning the general strains and loads that usually apply upon prosthetic works, the authors present the virtual model of a molar tooth subjected to the most common actions, using finite element method. Then the results are further show...

A modified impeller mixing coupled with chill casting technique was used for the preparation of immiscible alloys. In this paper Al-Fe binary alloys was chosen for this study. This binary system shows the miscibility gap at specified concentration and temperature. The electrolytic grade iron powder of 300mesh size was dispersed in the melt of commercially pure aluminum. The iron content in the ...

Biofuel pellets were prepared from biomass (pine, chestnut and eucalyptus sawdust, cellulose residue, coffee husks and grape waste) and from blends of biomass with two coals (bituminous and semianthracite). Their mechanical properties and combustion behaviour were studied by means of an abrasion index and thermogravimetric analysis (TGA), respectively, in order to select the best raw materials ...

This paper reports the mechanical design and optimization of tunable Fabry-Perot (FP) filter structures for the development of MEMS adaptive infrared detectors using finite element modeling and experimental investigations. The results indicate that the mechanical characteristics of the FP filters are significantly influenced by the structural designs, which eventually affect the filter performa...

1 Key Laboratory of Advanced Technologies of Materials, Ministry of Education, School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu, China, 2 Center of Nanomaterials for Renewable Energy, State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an, China, 3 Institute of Nuclear Physics and C...