In this study, we introduce a zero-IF sub-harmonic mixer with high isolation in the 5GHz band using 0.18μm CMOS technology. Placing an LC-Tank between the class AB stage and the mixer core improves the isolation between the LO and RF ports. The measured isolation is obtained with a 48 dB between LO and RF ports; and a 9.5dB conversion gain is acquired while consuming 7mA at 2.5V supply voltage....

A down conversion RF mixer is designed with 65nm CMOS technology for a different low power consumption applications. Mixer structure comprises a double-balanced Gilbert-Cell with improving linearity method in the RF stage of circuit; all is at a supply voltage of 1.8V and a power of 2.17 mW. The circuit is simulated for different spectrum applications as: 200 MHz mobile users, 1.9 GHz wireless ...

In recent years, the CMRC filter has been an attractive candidate for use in mixer and frequency multiplier circuits to improve the performance due to its low-insertion loss, sharp rejection, shorter size and wider stop-band. However, complex structures, too much variables and inefficient design method hindered its widespread use. In this study, we report on the application of the implicit spac...

The mixing behavior around a SMX-type static mixer segment has been investigated experimentally by using Particle Image Velocimetry (PIV) and Planar Laser-Induced Fluorescence (PLIF) simultaneously. To quantify mixing, velocity fields and concentration fields have been measured for different Reynolds numbers along vertical and horizontal sections directly behind the mixer. The experimental data...

The microwave circuit simulator MMICAD can be used to analyze and optimize the small-signal conversion and noise performance of a mixer-preamplifier. The mixer is represented as a noisy five-frequency five-port network using imported conversion and noise correlation matrices, with MMICAD’s NCSCOR5 element which contains five correlated noise sources.

The present work consists of designing a Single Balanced Mixer (SBM) with the 65 nm CMOS technology, this for a 1.9 GHz RF channel, dedicated to wireless applications. This paper shows; the polarization chosen for this structure, models of evaluating parameters of the mixer, then simulation of the circuit in 65nm CMOS technology and comparison with previously treated.

As an extension of our previous study, the flow and mixing characteristics of a serpentine mixer in non-creeping flow conditions are investigated numerically. A periodic velocity field is obtained for each spatially periodic channel with the Reynolds number (Re) ranging from 0.1 to 70 and the channel aspect ratio from 0.25 to one. The flow kinematics is visualized by plotting the manifold of th...

This work proposes a symmetrical offset stack coupled lines balun and a dual balun for a single balanced mixer and a star mixer, respectively. To achieve a minimum insertion loss and a maximum bandwidth, the design formulas are derived by properly selecting the width of coupled lines and the offset width between two coupled lines. The measured results of the proposed single and dual baluns achi...

Two novel passive micromixers, denoted as the Y-Y mixer and the H-C mixer, based on split-and-recombine (SAR) principle are studied both experimentally and numerically over Reynolds numbers ranging from 1 to 100. An image analysis technique was used to evaluate mixture homogeneity at four target areas. Numerical simulations were found to be a useful support for the design phase, since a general...

The design of a low noise figure (NF), high conversion gain (CG) double-balanced, Gilbert-cell mixer is presented. Since the noise figure of the RF CMOS mixer is strongly affected by flicker noise (1/f), a dynamic current injection technique is used to reduce the flicker noise corner frequency. The current injection circuitry comprises 3 pMOS to inject current pulses at the switching instants. ...