OBJECTIVES To determine the static load-bearing capacity of direct composite onlay restorations made of novel filling composite resin system which combines short fiber-reinforced composite resin (FC) and conventional particulate filler composite resin (PFC). METHODS Three groups of onlay restorations were fabricated (n = 8/group); Group A: made from conventional particulate filler composite r...

abstract statement of problem: there is no enough published data about the shear bond strength of resin modified glass ionomer adhesives on caries-affected primary tooth dentin excavated using minimally invasive systems. objectives: to evaluate the shear bond strength of 2 different adhesives (one resin modified glass ionomer and one resin) using two caries removal techniques on healthy and car...

A NIR method was developed for the on-line monitoring of alkali-free cloth/phenolic resin prepreg during its manufacturing process. First, the sizing content of the alkali-free cloth was analyzed, and then the resin, soluble resin and volatiles content of the prepreg was analyzed simultaneously using the FT-NIR spectrometer. Partial least square (PLS) regression was used to develop the calibrat...

The purpose of this study was to evaluate the effect of a resin coating technique on the microtensile bond strength (microTBS) of resin cement to dentin in composite crown restorations. Crown preparations were done on human molars. A resin coating material, Hybrid Bond, was immediately applied to the prepared dentin and light-cured, while the tooth without resin coating acted as the control. An...

OBJECTIVES Adhesion of resin composites to dentin is currently believed to result from impregnation of adhesive resin into superficially demineralized dentin. The purpose of this study was to use micro-Raman spectroscopy and scanning electron microscopy (SEM) to investigate the extent of resin penetration into etched dentin with single-step adhesive systems. METHODS Adhesive systems used were...

An experiment was conducted to investigate the effects of the resin solid content, catalyst content, and pH value obtained by the addition of two kinds of catalysts on the gel time of a urea–formaldehyde (UF) resin. Upon the addition of ammonium chloride, the pH value of the resin mixture decreased to 7 but not significantly further because of the limited free formaldehyde in the system. The pH...

Statement of the problem. The fracture of acrylic resin dentures remains an unsolved problem. Therefore, many investigations have been performed and various approaches to strengthening acrylic resin, for example, the reinforcement of heat-cured acrylic resin using glass fibers, have been suggested over the years. But problems such as poor workability, rough surface, poor adhesion of glass fiber...

Minimally invasive restorative techniques can be applied with direct resin composites. However, the preparation for an indirect restoration tends to lead to over-treatment of the tooth structures. A resin-coating technique has been proposed in which both a hybrid layer and a tight sealing film are produced on the dentin surface with a dentin adhesive system and a low viscosity micro-filled resi...

INTRODUCTION We aimed to compare apical canal transportation of extracted teeth and two types of simulated resin blocks. MATERIALS AND METHODS Mesiobuccal root of extracted maxillary molars, high hardness simulated resin blocks (Knoop hardness=40) and low hardness simulated resin blocks (Knoop hardness=22) were prepared with K-files using step-back technique (n=15 canals in each group). Doubl...

The newly introduced self-adhering flowable resin-composites Background: decrease the required time for application by incorporation of an acidic adhesive monomer, thus reducing the number of the steps, but its bonding is still uncertain. The aim of this study was to evaluate the interfacial microscopic examination and chemical analysis at the resin-dentin interface of a self-adhering flowable ...