the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...

Previous work on the elastic deformation of flat-section band clamps has been extended to account for plastic deformation of the band material. Both finite element analysis using a multilinear plastic model and a classical approach using a continuous plastic equation are reported. The excellent agreement between the results of these two approaches provides a high level of confidence in the mode...

Purely elastic, partially and fully plastic stress states in a thick-walled spherical pressure vessel with an inner functionally graded material (FG) coating subjected to internal and external pressures are developed analytically in this paper. The modulus of elasticity and the uniaxial yield limit of the FG coating layer are considered to vary nonlinearly through the thickness. Using Tresca’s ...

The deformation behavior of bulk ZnO single crystals is studied by a combination of spherical nanoindentation and atomic force microscopy. Results show that ZnO exhibits plastic deformation for relatively low loads ~*4–13 mN with an ;4.2 mm radius spherical indenter!. Interestingly, the elastic–plastic deformation transition threshold depends on the loading rate, with faster loading resulting, ...

The plastic deformation of Ti45Zr16Be20Cu10Ni9 bulk metallic glass has been investigated by nanoindentation performed with loads ranging from 10 to 200 mN in a wide range of loading rates. The plastic flow in the alloy exhibited conspicuous serrations at low loading rates. The serrations, however, became less prominent as the rate of indentation increased. Atomic force microscopy showed a signi...

We consider elasto-plastic deformations of a body which is subjected to a time-dependent loading. The model includes fully nonlinear elasticity as well as the multiplicative split of the deformation gradient into an elastic part and a plastic part. Using the energetic formulation for this rate-independent process we derive a time-incremental problem, which is a minimization problem with respect...

Yu-Lin Wu,2 Hai-Bao Chen, Kun Jiang, Ying Li, Feng Shan, Dong-Ye Wang, Yan-Fang Wang, Wen-Ming Wu, Yikang Wu, Zhu-Jun Yao, Zheng-Yu Yue and Cheng-Ming Zhou State Key laboratory of Bio-organic and Natural Products Chemistry, Shanghai Institute of Organic Chemistry, Chinese Academy of Sciences, Shanghai 200032, China; Shanghai Institute of Materia Medica, Chinese Academy of Sciences, Shanghai 200...