When polymeric solids slide against other solids such as steel there appears to be no way to predict either the friction of the system or the wear life of the polymer from handbook data. Friction and wear vary over wide ranges when sliding speed, applied load and system temperature are varied. Neither have thermal analyses of the sliding system produced satisfying results, partly because of the...

In this study, the effects of cerium (Ce) addition on the friction and wear properties of surface welding AZ91 magnesium alloys were evaluated by pin-on-disk dry sliding friction and wear tests at normal temperature. The results show that both the friction coefficient and wear rate of surfacing magnesium alloys decreased with the decrease in load and increase in sliding speed. The surfacing AZ9...

Flowability - as measured by hopper discharge rate, angle of repose and Carr's index (CI) - of surface modified microcrystalline cellulose granules was investigated experimentally. Three-dimensional simulations of the granule flow were performed, using the discrete element method (DEM), including either sliding and rolling friction or sliding friction and cohesion in the model. Granule surface ...

The classical problem of rebound is usually treated by assuming that the colliding bodies are rigid and that the coefficient of friction, ~ , is constant. Two contact states can be distinguished: slidinq, in which the ratio of friction force to normal force is equal to ~ , and rolling, in which the friction force is zero. If sliding gives way to rolling during impact, the friction force will fa...

We present results from an independent analysis of friction that more generally addresses all crystalline materials by an extension of coincident site lattice theory and dislocation drag. Calculations for graphitic friction are carried out and agree in magnitude with experimental friction forces. More interestingly, static, dynamic and anisotropic friction forces, incommensurability effects and...

The friction and wear properties of polyamide 66 (PA66), polyphenylene sulfide (PPS) and polytetrafluoroethylene (PTFE) sliding against hemselves under dry sliding and oil-lubricated conditions were studied by using a pin-on-disc tribometer. The effect of applied load and sliding peed on tribological behaviors of the polymer–polymer sliding combinations under dry sliding and oil-lubricated cond...

A robust positioning control scheme has been developed using friction parameter observer and recurrent fuzzy neural networks based on the sliding mode control. As a dynamic friction model, the LuGre model is adopted for handling friction compensation because it has been known to capture sufficiently the properties of a nonlinear dynamic friction. A developed friction parameter observer has a si...

Polyvinyl ester green composites were synthesized with walnut shell powder (WSP) by in-situ polymerization technique. The green composites have been evaluated for mechanical properties such as tensile strength, tensile modulus and hardness. Sliding wear loss, specific wear rate and coefficient of friction were investigated by using computerized pin-on–disc machine at normal applied loads of 20,...

In rehabilitation training, high-fidelity simulation environments are needed for reproducing the effects of slippery surfaces, in which potential balance failure conditions can be reproduced on demand. Motivated by these requirements, this article considers the design of variable-friction devices for use in the context of human walking on surfaces in which the coefficient of friction can be con...

Single asperity friction experiments using atomic force microscopy (AFM) have been conducted on chemical vapor deposited (CVD) graphene grown on polycrystalline copper foils. Graphene substantially lowers the friction force experienced by the sliding asperity of a silicon AFM tip compared to the surrounding oxidized copper surface by a factor ranging from 1.5 to 7 over loads from the adhesive m...