Isokinetic moment ratios of the hamstrings (H) and quadriceps (Q) muscle groups, and their implication in muscle imbalance, have been investigated for more than three decades. The conventional concentric H/Q ratio with its normative value of 0.6 has been at the forefront of the discussion. This does not account for the joint angle at which moment occurs and the type of muscle action involved. A...

The average ionic strength of 20 West Australian soils was found to be 0·0048. The effects of three electrolytes (deionized water, CaCl2 and KN03), three ionic strengths (0'03. 0·005 and soil ionic strength at field capacity, Is) and two soil liquid ratios (1:5 and 1:10) on the pH of 15 soils were investigated. pH measurements in solutions of ionic strength 0·005 differed the least from measure...

Abstract—In this study, the effects of waste marbles as aggregate material on workability and hardened concrete characteristics of self compacting lightweight concrete are investigated. For this purpose, self compacting light weight concrete are produced by waste marble aggregates are replaced with fine aggregate at 5%, 7.5%, and 10% ratios. Fresh concrete properties, slump flow, T50 time, V fu...

Structural lightweight concrete (SLWC) has superior properties that allow the optimization of super tall structure systems for the process of design. Because of the limited supply of lightweight aggregates in Korea, the development of structural lightweight concrete without lightweight aggregates is needed. The physical and mechanical properties of specimens that were cast using normal coarse a...

This study presents the result of using melting to recover both industrial sludge slag (the main constituent of which is calcium fluoride) and water works sludge slag as fine aggregate in cement. The main characteristics of both slag and cement mortars were measured to evaluate the feasibility of using slag as aggregate. In this study, the slag replacement ratios were 0, 10, 20, 30, 40, and 50%...

The compressive strength of five different amalgams was measured at one hour, six hours, 24 hours, and seven days, and X-ray diffraction analysis was carried out for each amalgam at the same times in order to investigate the early strength characteristics of the amalgams in relation to the formation of different phases. At 24 hours all tested amalgams reached about 90% or more of their seven-da...

The most important physico-chemical characteristics describing detergent micelles are the CMC value and the aggregation number. These parameters depend critically on external conditions such as pH, ionic strength, buffer composition or temperature. However, the influence of these conditions on CMC or aggregation number is a priori not to predict, but the most important parameter. This holds esp...

In this study, the amount of cement used in a concrete mix is minimized to reduce the toxic effects on users by adjusting the concrete mixture contents. The reduction of cement is achieved by using various admixtures (ground granulated blast-furnace slag, flyash, ordinary Portland cement, and activated Hwangtoh powder). To apply the mix to construction, material property tests such as compressi...

The purpose of this study was to compare maximal torque exerted about the craniocervical (CC) and cervicothoracic (CT) axes in the sagittal plane using a novel dynamometry device. Maximal voluntary contraction (MVC) recordings in newton-meters (N·m) were measured in 20 males and 20 females for each of 4 tests: CT extension, CT flexion, CC extension, CC flexion. Twenty of the volunteers repeated...

This study was carried out to test the ability of a mixture of sand, cement and clay for immobilizing cadmium ions from leaching out into water resources. Various samples with different mass ratios for this mixture were tested to determine their efficiency for adsorbing cadmium. The compressive test, cation exchange capacity (CEC), adsorption equilibrium and leaching test were applied to each s...