The photocatalytic activity of phosphonated Re complexes, [Re(2,2'-bipyridine-4,4'-bisphosphonic acid) (CO)3(L)] (ReP; L = 3-picoline or bromide) immobilised on TiO2 nanoparticles is reported. The heterogenised Re catalyst on the semiconductor, ReP-TiO2 hybrid, displays an improvement in CO2 reduction photocatalysis. A high turnover number (TON) of 48 molCO molRe(-1) is observed in DMF with the...

Blinking photoluminescence was observed in single TiO2 nanodiscs (NDs) by using a laser scanning confocal microscope (LSCM)-coupled steady-state and ps-time-resolved photoluminescence (PL) spectroscopic system, while it was not significantly observed for TiO2 quantum dots (QDs). Analysis of the PL blinking time trajectories revealed single-exponential kinetics with the average lifetimes of on-s...

The low quantum yields and lack of visible light utilization hinder the practical application of TiO2 in high-performance photocatalysis. Herein, we present a design of TiO2 nanopillar arrays (NPAs) decorated with both Au and Pt nanoparticles (NPs) directly synthesized through successive ion layer adsorption and reaction (SILAR) at room temperature. Au/Pt NPs with sizes of ~4 nm are well-disper...

Parylene films loaded with TiO2 are reported as photocatalysts in azo dye discoloration processes. The TiO2 loading of the parylene film was 0.32% (w/w) and the amount of TiO2 on the film was about two orders of magnitude below the TiO2 added in suspension to discolore the same solution of Methyl Orange used as a probe. The parylene/TiO2 films showed a similar activity in the presence of O2 or ...

This paper describes an easy and time-saving strategy for the fabrication of heterogeneous nanotubular arrays of TiO2-CdS (TCHNTAs) on transparent conductive glass (FTO) and their photoelectrochemical properties. The use of transparent FTO instead of opaque Ti substrate allows incident light from the substrate side. The anodized TiO2 nanotubular arrays were firstly detached from Ti substrate by...

Tuning the band alignment is proved to be an effective way to facilitate carrier transportation and thus enhance the power conversion efficiency (PCE) of solar cells. Doping the compact layer with metal ions or modifying the interfaces among functional layers in perovskite solar cells (PSCs) can appreciably improve the PCE of PSCs. Inspired by the rare earth elemental doping of TiO2, which has ...

In this article, a novel route for the synthesis of graphene/TiO2 continuous fibers (GTF) using force-spinning combined with water vapor annealing method is reported for the first time. The morphology, structure and optical properties of the composite were fully characterized. With a single step of heat treatment process using steam at ambient conditions, we were able to initiate a series of ch...

Heterogeneous TiO2/Cu2O nanocomposite was synthesized for photocatalysis through surface impregnation in conjunction with the environmentally friendly soft chemical reduction strategy. The detailed structural, compositional, optical and photoelectrochemical properties of the obtained products are analyzed by X-ray diffraction (XRD), transmission electron microscopy (TEM), UV-Vis diffuse refl ec...

We fabricated a sandwich-like branched-polyethyleneimine (b-PEI)/TiO2/Au/graphene oxide (GO) nanocomposite through a biomimetic layer-by-layer co-mineralization approach, and the polymer b-PEI was believed to act as both an inducing agent for the hydrolysis of titanium bis(ammonium lactato)-dihydroxide (Ti-BALDH) and a reducing agent for the reduction of HAuCl4 in the synthetic procedure. Upon ...

Photocatalysis is a promising method for the disinfection of potable water in developing countries where solar irradiation can be employed, thus reducing the cost of treatment. In addition to microbial contamination, water normally contains suspended solids, dissolved inorganic ions and organic compounds (mainly humic substances) which may affect the efficacy of solar photocatalysis. In this wo...