The ultrasonic infrared thermal wave method is a new nondestructive testing technique. It is remarkably sensitive and convenient for detection of small vertical cracks, such as fatigue cracks in metals. Pulses of ultrasonic launched by the ultrasonic emitter as heat source are excited into the sample, if there are some cracks in the material, they will be revealed through their heat generation,...

Steel structures continuously exposed to offshore marine environments are prone to corrosion. This can be of major economic and perhaps of environmental significance. The risk of these scenarios occurring can be assessed using good quality data, good quality corrosion and pitting models and structural reliability assessment. Recently, improved models for the prediction of longer term corrosion ...

One source of structural vibration in a submarine is the fluctuating axial thrust force applied to the thrust block by the propeller shaft. This paper describes the initial stages of experimental work being undertaken to validate an existing mathematical model for the sound radiation from a submarine excited by this mechanism. A thin cylindrical shell 1500mm long and 400mm in diameter made of 2...

S. Bulatović, Yugoslav River Shipping, Serbia, Lj. Milović, University of Belgrade, Faculty of Technology and Metallurgy, Serbia, A. Sedmak, University of Belgrade, Faculty of Mechanical Engineering, Serbia, I. Samardžić, University of Osijek, Mechanical Engineering Faculty, Slavonski Brod, Croatia Low cycle fatigue test was performed in ambient atmosphere at room temperature. Cycle loading of ...

In this research the interface structure of dissimilar joint between AISI 4130 and AISI316L steels produced by GTAW process was evaluated. ERNiCr-3 was used as a filler metal for this joint. After welding the microstructure of different areas including weld metals, heat affected zones and interfaces were studied by optical microscope (OM), scanning electron microscope (SEM) and energy dispersiv...

The paper demonstrates the correlation between the chemical composition of steel grades and the hardness as well as the formability of laser welds generated with modern automotive high strength steel grades. At the very low heat input of industrial laser welding and the resulting extremely high cooling rate, the weld hardness is fully controlled by the carbon content of the base materials and n...

Original scientific paper The microstructural transformations which took place during the welding of duplex steel as well as their influence on the resistance to particle erosion wear and cavitation erosion wear were investigated. A sample was cut from a 1.4462 rolled steel plate and heat treated in order to obtain a microstructure which would resemble, as closely as possible, the actual welded...

Fe-2.25Cr-1Mo a widely used material for headers and steam tubes of boilers. Welding of steam tube to header is required for production of boiler. Heat affected zone of the weld can have poor mechanical properties and poor corrosion behavior leading to weld failure. The cost of material used for steam tube and header of boiler should be controlled. This study propose a new materials design for ...

Electrical-current-assisted friction stir welding (EA-FSW) is a procedure developed for the joining of similar and dissimilar materials. EA-FSW newly invented solid-state process to increase welded components’ efficacy in various applications, such as marine structures. joints have investigated on aluminum–magnesium, aluminum–steel, polymer-to-steel. Similar been performed aluminum, magnesium, ...

1 ATE-80212044©Asian-Transactions September 2012 Study the Effect of Welding Joint Location on the Fatigue Strength and Fatigue Life for Steel Weldment Dr.Ali Sadiq Yasir Kufa University / Faculty of Engineering Mechanical Engineering Department IRAQ E-mail:[email protected] / [email protected] Abstract: The welding process is one of the oldest joining processes between the ma...