Flash processing is a new heat treatment process being developed to produce steel with relatively high strength and ductility. It involves rapidly heating steel sheet or strip to a temperature in the austenite range and quenching; the entire thermal cycle takes place within 15 seconds. The resulting microstructure is fine and difficult to resolve using standard metallographic techniques. In thi...

Article history: Received 12 September 2010 Accepted 27 September 2010 In this paper, the residual stress in quenched AISI 1045 steel was measured by a recently developed nanoindentation technique. Depth control mode was adopted to measure the residual stress. It was found that residual compressive stress was generated in the quenched steel. The material around nanoindents exhibits significant ...

Warm laser shock peening (WLSP) is a thermomechanical treatment technique combining the advantages of laser shock peening and dynamic strain aging (DSA). Through DSA, WLSP of steel increases the dislocation density and stabilizes the dislocation structure by pinning of mobile dislocations by carbon atoms. In addition, WLSP generates nanoscale carbide precipitates through strain-induced precipit...

Angle sections are commonly designed to bear only axial force, usually neglecting the additional bending moments resulting from the eccentric connection and the shift of the effective centroid. The current work deals with the capacity of single-bolted equal angle sections made from cold-formed steel. The experimental investigation presented herein includes tension and compression tests that sub...

Metal cutting is a severe plastic deformation process involving large strains, high strain rates, and high temperatures. Conventional analysis of the chip formation process is based on bulk material deformation disregarding the inhomogeneous nature of the material microstructure. A series of orthogonal cutting tests of AISI 1045 and 1144 steel were conducted which yielded similar process charac...

Modulus of elasticity of flapper valve material is an important parameter for compressor design since it can affect efficiency and life time of the compressor. Modulus of elasticity is usually considered as a material constant. Actually, it can vary with material orientations and conditions and even environments such as temperature will also affect this value. Therefore, the parameters that can...

In a time when modern production has become exposed to strict market demands, in terms of increasing quality, shortening the processing time and reducing the cost of the final product, laser processing has become a necessity in almost all manufacturing industries. Each laser manufacturer, including the Swiss company Bystronic, gives recommended cutting parameters for certain types of materials....

The chemical modifications introduced in the passive layer of AISI 304 stainless steel after Si, Ce, and Mo ion implantation were investigated and compared with non-implanted steel by soft X-ray absorption spectroscopy. The influence of ion implantation on the passive properties was evaluated by measuring soft X-ray absorption spectra at the Cr, Fe, Ni, Mn and Si 2p in addition to oxygen 1s thr...

This paper presents a method to perform a surface finish control using a computer vision system. The goal pursued was to design an acceptance criterion for the control of surface roughness of steel parts, dividing them in those with low roughness acceptable class and those with high roughness defective class. We have used 143 images obtained from AISI 303 stainless steel machining. Images were ...